Style 409-R Mounting Kit
Thank you for purchasing a Shakespeare antenna product.
Customer comments are welcome. Before installing, please study
the diagram and check parts supplied against those listed.
Retainer Bar
Wing Nut
Reducing Adapter
Antenna
Standoff Bracket
Assembly
IMPORTANT! Please read all instructions
before installing.
STANDOFF
BRACKET
Mounting
Screw*
The Style 409-R Mounting Kit is a versatile antenna
mounting kit comprised of a Shakespeare Style 407 Heavy Duty
4-Way Swivel Mount and a Shakespeare Style 408-R Standoff
Bracket. The swivel mount permits mounting on almost any
surface, vertical or horizontal, and allows antenna laydown
in any desired direction. For use with 1½” antennas, and
antennas of 11/8” and 1” diameter by using the appropriate
adapter (supplied) in the standoff bracket.
Supplied Parts
1 Standoff Bracket assembly
1 1” Reducing adapter
1 11/8” Reducing adapter
1 Swivel Mount assembly
1 Mount base plate
Washer*
Lockwasher*
Nut*
Tools required: Drill and drill bit for ¼” screws;
screwdriver; wrench or pliers
3
1 /8“ Hex-head Bolt
Installation Instructions
3
1 /8“ Internal Tooth Lockwasher
Choose an antenna mounting location that is as high as
feasible, as free as possible from obstructions, and as far as
possible from other antennas and strong sources of RF.
3
1 /8“ Plain Washer
3
1 /8“ Hex Nut
1. Using the base of the Swivel Mount as a template, mark the
location for the four mounting holes. Drill ¼” holes.
Bulkhead Mounting: SIDE VIEW
Mounting
Note: When drilling fiberglass, place a wooden backup block
behind the surface if possible, to minimize push-through
damage.
Lockwasher*
Nut*
1”-14 Thread
Screw*
Bolt
2. Assemble the Swivel Mount by joining its two sections and
securing them with the hex-head bolt, washer, lockwasher and
nut (supplied). This joint can be in two positions, according to
whether you’re mounting to a vertical or horizontal surface.
3. Attach the Swivel Mount to the mounting surface using
hardware (not supplied) that is applicable to the mounting
surface.
Bulkhead
Mounting:
Swivel
Bolt
FRONT
VIEW
IMPORTANT: If the thickness of the mounting
surface is not adequate to support the antenna
under expected stress, a wooden back-up pad
(not supplied) should be applied underneath the
mounting surface during installation.
Mounting
Screw*
Mounting Hole
4. Assemble the antenna to the Swivel Mount, being careful not
to damage the antenna’s cabling, if any.
Base Plate
5. Loosen the wing nut on top of the Standoff Bracket and slide
the retainer bar out of the way. Gently place the antenna in
its mounting position in the U-shaped opening in the bracket.
For 11/8” and 1” antennas, put the appropriate reducing adapter
(supplied) in the opening.
Nut*
Lockwasher*
Deck Mounting: SIDE VIEW
* Not supplied. For some types of mounting surfaces you might need
stainless steel woodscrews or other hardware.
Shakespeare Electronic Products Group
Shakespeare is a subsidiary of Jarden Corporation (NYSE: JAH)
©2002 Shakespeare Co.
· Form I-409-R J: rev. 04/25/2010
|