Soleus Air Fan FS1 40R 33 User Manual

16” Stand Fan with Remote Control  
Model No: FS1-40R-33  
Operating Instructions  
3072986  
FS1-40R-33  
© 2006 Soleus Air International  
 
WARNING: This heater is equipped with a polarized plug (one blade is wider than the other). The plug is in-  
tended to fit into a power outlet only one way, with the wide blade in the wide slot. This is a safety feature; if  
you are unable to insert the plug fully into the outlet, try reversing the plug. If the plug still does not fit, contact  
a qualified electrician.  
DO NOT DEFEAT THE SAFETY PURPOSE OF THE POLARIZED PLUG.  
TECHNICAL SPECIFICATIONS  
Voltage Rating  
Power Consumption  
Unit Size  
120V, 60Hz  
55W  
17.50 in. (W) x 15.75 in. (D) x 51.13 in. (H)  
14 lbs  
Unit Weight  
3
 
PRODUCT DIAGRAM  
4
 
ASSEMBLY INSTRUCTIONS  
Tools required: Phillips screwdriver (not included)  
Remove the fan and packaging materials from the box.  
Base Assembly  
1. Attach the Lower Pole (M) to the Fan Base (N) with the included Screws (P) and  
Washers (O).  
2. Attach the Upper Pole (I) to the Lower Pole (M) and tighten the screw located on the  
bottom of the Upper Pole (I).  
Fan Head Assembly  
1. Unscrew (turn clockwise) the Fan Blade Cap (C) if it attached to the Motor Shaft (G).  
Note: Fan Blade Cap (C) may be included in a plastic bag and not attached to the Motor  
Shaft (G).  
2. Unscrew (turn counter-clockwise) the Mounting Nut (E) from the Motor Shaft (G).  
3. Position the Rear Grill (F) over the Motor Shaft (G), fitting the holes in the Rear Grill  
(F) over the knobs that protrude from the motor. Make sure the grill fits securely against  
the motor housing.  
4. Screw-on (turn clockwise) the Mounting Nut (E) to secure the Rear Grill (F) to the Mo-  
tor Housing (H).  
5. Attach the Fan Blade (D) to the Motor Shaft (G) by aligning the slots on the Fan Blade  
(D) with the bars on each side of the Motor Shaft (G).  
6. Secure the Fan Blade (D) onto the Motor Shaft (G) by turning the Fan Blade Cap (C)  
counter-clockwise.  
7. Align the Front Grill (A) with the Rear Grill (F).  
8. Place the Grill Ring (B) on the outer most edge of the Grill and secure using a Phillips  
head screwdriver.  
5
 
OPERATING INSTRUCTIONS  
Using Fan Controls  
1. Set the fan on a stable, level surface.  
2. Turn the fan on by pressing the POWER/SPEED button located on the control panel below the Multi-Color  
display, or the POWER/SPEED button on the Remote Control.  
3. Adjust the speed setting by pressing the POWER/SPEED on the control panel or remote control.  
4. Pressing the MODE button on either the fan or the remote will choose the desired wind mode: Standard,  
Sleep, & Natural. In standard mode the fan operates at a steady speed. In Sleep mode the fan decreases  
speed in the middle of the oscillation pattern. Natural mode simulates the wind by randomly alternating the  
fan speed.  
5. To oscillate the fan head, press the SWING button located on the fan or the remote.  
6. This fan includes a 12 hour timer. To operate the timer, press the TIMER button (located on the fan &  
remote) until the desired time is visible on the Multi-Colored Display. Each button press will increase the  
time by 1 hour increments. Once the timer is set the words “TIMER” and “HR” will light up on the  
display.  
7. To turn the fan off, press the POWER/SPEED button on the fan, or the remote control until the unit turns  
off.  
Using the Auto-on Feature  
1. First turn the fan on by pressing the POWER/SPEED button Set the fan on the fan control panel or remote  
control.  
2. Once the fan is on, press the AUTO button located on the remote control. Please note, the Auto-on function  
is accessible by using the remote control only.  
3. “AUTO” should now be displayed on the multi-color display along with the current room temperature.  
When the fan is in auto mode, it will vary speeds according to the room temperature. When the room  
temperature is below 68° the fan will be in standby mode (off). When the temperature is between 68° F and  
74° F the fan will operate at low speed (1). When the temperature is between 75° F and 81° F the speed  
will increase to medium (2). The fan will operate at high speed (3) once the room temperature is equal to or  
greater than 82° F.  
Adjusting Height and Fan Head Tilt  
1. To adjust the height of the fan, turn the Adjustable Height Knob (L) counter-clockwise to loosen the  
stand. Adjust the fan to the desired height, then firmly tighten to secure into place.  
2. To adjust the tilt on the Fan Head, loosen the knob below the Motor Housing and tilt the fan  
forward/back by pulling or pushing the top of the Fan Grill. The fan will make a clicking noise while  
being adjusted. Once the Fan Head is set to the desired tilt, tighten the knob to secure into place.  
6
 
CLEANING & MAINTENANCE  
1. Turn the fan off and unplug the unit.  
2. Wipe the fan down with a damp cloth for most efficient operation.  
3. Air dry the fan completely before use.  
4. Never use abrasive cleaning agents or solvents. This may cause damage or deterioration to the surface of  
the unit.  
5. Do not immerse the fan in any form of liquid. Do not allow water to drip on or into the fan motor  
housing.  
Fan Blade Cleaning:  
Make certain the fan is unplugged. Unlock the metal clips on the front grill and remove the front grill. Use  
a Phillips screwdriver to loosen the securing screw and remove the fan blade.  
The fan blade and grill may be cleaned with a damp cloth and mild detergent.  
Reassemble the fan after the parts have dried completely. To do so, replace the fan blade, tighten the  
securing screw, and secure the front grill. Do not plug the fan into an electrical outlet until it is fully  
reassembled.  
STORAGE  
If the fan will not be used for a long period of time, store it in a cool, dry location when not in use. To  
prevent dust and dirt build-up, use the original packaging to repack the unit.  
OVERHEAT PROTECTION  
A thermostat is built-in to the motor to prevent overheating. If the fan temperature exceeds the limit on the  
thermostat, the fan will automatically shut-off to prevent overheating and protect the fan components from  
damage.  
REMOTE CONTROL  
The supplied remote uses 2 “AAA” batteries. The remote will work at a distance of roughly 25 feet, and an  
angle of 60°.  
7
 
WARRANTY  
One Year Limited Warranty  
Soleus International Inc. warrants the accompanying Soleus Air FS1-40R-33 16” Stand Fan to be free of defects in ma-  
terial and workmanship for the applications specified in its operation instruction for a period of ONE (1) year from the  
date of original retail purchase in the United States.  
If the unit exhibits a defect in normal use, Soleus International Inc. will, at its option, either repair or replace it, free of  
charge within a reasonable time after the unit is returned during the warranty period.  
As a condition to any warranty service obligation, the consumer must present this Warranty Certificate along with a  
copy of the original purchase invoice.  
THIS WARRANTY DOES NOT COVER:  
Damage, accidental or otherwise, to the unit while in the possession of a consumer not caused by a defect in  
material or workmanship.  
Damage caused by consumer misuse, tampering, or failure to follow the care and special handling provisions  
in the instructions. This includes dents, accidental or otherwise, to the base and head of the unit.  
Damage to the finish of the case, or other appearance parts caused by wear.  
Damage caused by repairs or alterations of the unit by anyone other than those authorized by Soleus  
International Inc.  
Freight and Insurance cost for the warranty service.  
ALL WARRANTIES, INCLUDING ANY IMPLIED WARRANTY OF MERCHANT ABILITY ARE LIMITED TO  
ONE-YEAR DURATION OF THIS EXPRESS LIMITED WARRANTY. SOLEUS INTERNATIONAL INC.  
DISCLAIMS ANY LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES AND IN NO EVENT  
SHALL SOLEUS INTERNATIONAL INC’S LIABILITY EXCEED THE RETAIL VALUE OF THE UNIT FOR  
BREACH OF ANY WRITTEN OR IMPLIED WARRANTY WITH RESPECT TO THIS UNIT.  
This warranty covers only new products purchased from our authorized dealers or retailers. It does not cover used, sal-  
vaged, or refurbished products.  
As some states do not allow the limitation or exclusion of incidental or consequential damages, or do not allow  
limitation on implied warranties, the above limitations and exclusions may not apply to you. This warranty gives you  
specific legal rights, and you may also have other rights that vary from state to state.  
For Technical Support & Warranty Service  
Please Call (888) 876-5387  
Or Write To:  
Soleus International Inc.  
9451 Telstar Ave.  
El Monte, CA 91731 USA  
8
 

Sierra Monitor Corporation Air Cleaner IZS31 User Manual
SMSC Network Card LAN91C111 User Manual
Sony Car Satellite Radio System DSX S100 User Manual
Sony DVR DVW 2000P User Manual
Sony Stereo System CMT CP33MD User Manual
Spectra Laser Level LL300 User Manual
Summer Infant Baby Monitor 02094A User Manual
Suunto Watch D9 User Manual
Swann Home Security System SW347 WA2 User Manual
Sylvania TV VCR Combo SSC191 User Manual