IMPORTANT! PROBLEMS?
TM
Before taking Gyro Force™ back to the
retailer, call our friendly RC technicians at:
1-800-622-8339.
SPOILER
GYRO
STORAGE: The Gyro Force™ should be
stored indoors in the foam tray enclosed in
the box after each use.
ROLL WING
GYRO
FORWARD/
REVERSE
CONTROLLER
FORWARD/
REVERSE
TURBO
BATTERY
DOOR
FRONT
BUMPER
GYRO FORCE™
WHEELS
BATTERY INSTALLATION
Gyro Force™ requires one 9.6-V rechargeable and one 9-V battery to run (Included).
INSTALLING BATTERIES IN THE GYRO FORCE™
9.? VOLT
Battery
Compartment
Door
2
3
1 -
4 -
Locate the battery
door on the bottom
of the vehicle.
Connect the battery
wire to the car wire
as shown.
9.6-V
Battery
Unscrew to release
the battery door as
shown.
Replace the battery
door and tighten the
screw back into
place.
2 -
5 -
Turn
Vehicle
Over
3 -
Place the batteries
in the tray according
to the polarity
Battery
Compartment Door
1
Battery
Compartment
markings as shown.
INSTALLING CONTROLLER
9-VOLT BATTERY
Battery
Compartment
Door
1
1 -
2 -
Place the 9-V
Using a Phillips
3 -
Replace the battery
compartment door
and refasten the
9-V
screwdriver, undo the
hold-down screw and
remove the battery
compartment door.
battery in the battery
compartment, making
sure to follow the
correct + and - polarity
markings.
2
3
Battery
hold-down screw.
Battery
Compartment
GETTING STARTED
Turn the “ON-OFF” 3 -
1 -
The vehicle steers like a
switch to the “ON”
position.
skateboard. By positioning either
right or left, the vehicle will turn
right and then left/left and then
right. To steer, release the turn
button once the vehicle is pointing
in the direction desired.
2 -
Use Controller
to move vehicle
forwards or
backwards.
Note: If you press right or left while holding the Turbo
button, Gyro Force™ will roll over and perform stunts.
|