State Industries Water Heater STGPG 0303 User Manual

Commercial Gas Water Heater  
I
Meets ASHRAE 90.1b-1992, and C.E.C. and New York Codes for  
thermal efficiency and standby loss.  
I
Glass-Lined Tank – Exclusive corrosion protection with glass-lining.  
Multiple anodes provide corrosion protection.  
I
Power Gas Burner – Electronic flame monitoring with direct spark  
ignition. For added safety, all units are equipped with redundant gas  
valves. Power gas burner requires 120 volt 60Hz service. A  
NEGATIVE DRAFT is required in the vent piping. This is not a forced  
draft burner.  
I
Fully Automatic Controls – Safety shut off, high temperature limit  
control, dual thermostat (adjustable 120°F thru 180°F) for accurate  
temperature control. Maximum inlet gas pressure 14˝ W.C.  
I
Foam Insulation – Saves fuel, helps reduce standby heat loss.  
I
Jacket – made of heavy gauge steel with baked enamel finish over  
bonderized undercoat.  
I
Fully Certified by U.L.  
I
ASME Construction – Available on GPG81 140, GPG81 199, GPG81  
270 & GPG81 370. When specifying ASME construction, add the letter  
“A” at the end of the model number. 160 psi working pressure.  
I
A.G.A./ASME Rated Temperature & Pressure Relief Valve –  
Factory installed.  
I
Barometric Draft Damper – To ensure proper draft for maximum  
efficiency.  
I
Easy Cleaning – Handhole cleanout(s) allows easy cleaning.  
I
Professional Startup Service – Furnished to assure most efficient  
combustion and safe initial operation.  
CAUTION: Unit must be installed on non-combustible surface.  
Limited Warranty:  
Other Features:  
Two layers of high temperature ceramic fiber insulation in  
combustion chamber  
I
Limited Warranty Outline  
If the tank should leak any time during the first three years, under the  
terms of the warranty, State Water Heaters will furnish a replacement  
heater; installation, labor, handling and local delivery extra.  
– NOTE: This Outline Is NOT A Warranty. For complete information,  
consult the written warranty or State Water Heaters.  
Flame inspection port opening  
Mounted on rugged channel iron skids  
Multiple anodes for protection.  
Options:  
Illinois School Code on GPG81 199 to GPG81 370  
National Board Registration (ASME models only)  
Low water cutoff  
5 or 10 year extended limited warranty.  
ASME (ON SELECTED MODELS)  
The  
Expert’s  
WATER HEATERS  
Choice  
 

Sharp CRT Television 27F543 User Manual
Sharp Stereo System XL BD601PH User Manual
Silvercrest Hair Dryer SRHT 1500 A2 User Manual
Snapper Lawn Mower 12RTG36 User Manual
Sony Digital Camera DSC H1 User Manual
Sony Laptop VPCW21 User Manual
Sony Radio XDR S55DAB User Manual
Stamina Products Stepper Machine 40 0048 User Manual
Sunrise Medical Camping Equipment LAL 1100 User Manual
SV Sound Home Theater System 16 46CS User Manual