AutoGrinder
Automatic coffee grinder
Instruction Booklet
EM0415
Please read these instructions carefully
and retain for future reference.
Sunbeam’s Safety Precautions
SAFETY PRECAUTIONS FOR YOUR
SUNBEAM AUTO GRINDER.
• The grinder cannot operate without the lid in
position.
• Always place the unit on a flat, level surface.
• Switch off and unplug at power point before
cleaning.
Sunbeam is very safety conscious when
designing and manufacturing consumer products,
but it is essential that the product user also
exercise care when using an electrical appliance.
Listed below are precautions which are essential
for the safe use of an electrical appliance:
• Read carefully and save all the instructions
provided with an appliance.
• Do not use an appliance for any purpose
other than its intended use.
• Do not place an appliance on or near a hot gas
flame, electric element or on a heated oven.
• Do not place on top of any other appliance.
• Do not let the power cord of an appliance hang
over the edge of a table or bench top or touch
any hot surface.
• Always turn the power off at the power outlet
before you insert or remove a plug. Remove
by grasping the plug - do not pull on the cord.
• Turn the power off and remove the plug
when the appliance is not in use and
before cleaning.
• Do not use your appliance with an extension
cord unless this cord has been checked
and tested by a qualified technician or
service person.
• Always use your appliance from a power
outlet of the voltage (A.C. only) marked
on the appliance.
• This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they
have been given supervision or instruction
concerning use of the appliance by a person
responsible for their safety.
• Do not operate any electrical appliance with
a damaged cord or after the appliance has
been damaged in any manner. If damage is
suspected, return the appliance to the nearest
Sunbeam Appointed Service Centre
for examination, repair or adjustment.
• For additional protection, Sunbeam
recommend the use of a residual current
device (RCD) with a tripping current not
exceeding 30mA in the electrical circuit
supplying power to your appliances.
• Do not immerse the appliance in water
or any other liquid unless recommended.
• Appliances are not intended to be operated
by means of an external timer or separate
remote control system.
• This appliance is intended to be used in
household and similar applications such
as: staff kitchen areas in shops, offices and
other working environments; farm houses; by
clients in hotels, motels and other residential
type environments; bed and breakfast type
environments.
• Children should be supervised to ensure that
they do not play with the appliance.
• The temperature of accessible surfaces may be
high when the appliance is operating.
• Never leave an appliance unattended while
in use.
If you have any concerns regarding the performance and use of your appliance,
Ensure the above safety precautions are understood.
1
Features of your AutoGrinder
Transparent cover
For ease of use the cover of the AutoGrinder
also doubles as a measuring cup and being
transparent the user is able to observe the
coffee beans being ground.
Stainless steel grinding bowl
As coffee beans are oily and aromatic,the
stainless steel grinding bowl surface ensures
minimal transfer of flavours and odours.
One touch power button
Easy to operate, simply press the power
button and your work is done, the grinder will
automatically stop when the selected grind is
achieved.
Storage container
The storage container is ideal for storing
excess coffee grounds.
Cleaning brush
For easy cleaning use the small brush to
remove stubborn coffee grinds quickly and
with no fuss to ensure quality, fresh grinding
results every time.
2
Style of coffee grind
The AutoGrinder gives you 3 choices of grind;
coarse for percolated coffee, medium for drip
filtered coffee and fine for espresso coffee.
Sliding grind selector
Decide on the style of coffee grind and slide
the grind selector to the quantity of ground
coffee desired.
Cord storage
Convenient and clever cord storage, turn the
base of the grinder to retract the cord and
simply pull the cord out for use.
3
Handy hints for grinding coffee
beans with the Sunbeam
AutoGrinder
• For a good cup of coffee only grind the
amount you need for immediate use, as
ground coffee quickly loses its flavour and
aroma.
• Do not leave coffee beans or grounds in the
open air, for best flavour always store them
in an airtight container.
• Excess coffee beans or grounds can be
stored in the refrigerator or freezer as by
doing so will slow down the rate at which
the coffee reacts with the moisture in the
air.
• With the Sunbeam AutoGrinder coffee
beans can be ground from a range of
coarse to a very fine grind. The required
coffee grind will be determined by the
brewing method used or style of coffee
desired. The different brewing methods
include;
• When grinding more than 12 scoops of
coffee beans, pour beans into cover, then
turn the grinder upside down and lock onto
the cover. Be sure to align the arrow on the
lid/cover with the ‘unlock’ graphic on the
rear of the grinder and turn the cover to
the left/lock position.
BREWING METHOD
Espresso Machines
Stove top Espresso
Drip Filtered
GRIND
Fine grind
Medium grind
Medium grind
Coarse grind
Plunger or Percolator
4
Using your Sunbeam AutoGrinder
Before using your Sunbeam AutoGrinder,
wipe the stainless steel grinding bowl and
blades clean with a damp cloth and wash
the transparent cover in warm soapy water.
Dry thoroughly.
left/lock position.
5.Hold the plug and pull slowly to release
the stored cord. Plug the power cord into
a 230-240V AC power outlet and turn the
power ‘ON’.
Note: Allow to dry completely before using.
6.Select the style of coffee (Percolator, Auto
Drip, Espresso) and slide the grind selector
1.Place the AutoGrinder on a dry, level
surface.
2.Remove the cover of the AutoGrinder by
turning it to the right/unlock position, then
lift straight up.
to the quantity of ground coffee desired.
7.Press the ‘Power’ button to commence
grinding and then remove finger.
The Sunbeam AutoGrinder will stop
automatically when the selected grind
is achieved. To stop the grind cycle at
anytime, push the ‘Power’ button. When
the ‘Power’ button is pressed again, the
grinder will start from the beginning of the
timed cycle.
3.Using the measurements on the cover/lid,
fill with the desired amount of coffee
beans and pour into the grinding bowl.
Alternatively scoop the beans directly into
grinding bowl.
4.Replace and lock the cover onto the
AutoGrinder. Align the arrow on the lid/
cover with the ‘unlock’ graphic, on the rear
of the grinder, and turn the cover to the
Important: Do not remove the cover before
the blades have stopped moving.
8.Once the blades have stopped rotating
unplug the cord from the power outlet
and remove the cover. Gently tap the base
of the AutoGrinder to loosen the freshly
ground coffee from the stainless steel
grinding bowl.
Note: The AutoGrinder will only operate
when the cover is in the locked position.
5
Care and Cleaning
Do not immerse the motor base of the
AutoGrinder in water.
4.Hold the AutoGrinder and turn the base in
a clockwise direction to retract the power
cord.
Do not place the AutoGrinder in the
dishwasher.
1.When you have finished grinding, unplug
your Autogrinder from the power outlet.
2.Use the soft cleaning brush to clean
around the blades. Carefully wipe the
grinding bowl with a soft, damp cloth.
Important: Use care around sharp blades.
3.Wash the cover in warm soapy water. Rinse
and dry thoroughly. Wipe the exterior of the
AutoGrinder with a damp cloth.
5.The storage container and brush should be
washed in hot, soapy water. Rinse and let
dry.
6
Notes
Notes
12 Month Replacement Guarantee
In the unlikely event that this appliance develops any malfunction
within 12 months of purchase (3 months commercial use) due to
faulty materials or manufacture, we will replace it for you
free of charge.
Should you experience any difficulties with
your appliance, please phone our customer
service line for advice on 1300 881 861 in
Australia, or 0800 786 232 in New Zealand.
Alternatively, you can send a written claim
to Sunbeam at the address listed below.
On receipt of your claim, Sunbeam will
seek to resolve your difficulties or, if the
appliance is defective, advise you on how
to obtain a replacement or refund.
In Australia you are entitled to a
replacement or refund for a major failure and
for compensation for any other reasonably
foreseeable loss or damage. You are also
entitled to have the goods repaired or
replaced if the goods fail to be of acceptable
quality and the failure does not amount to
a major failure.
Should your appliance require repair or
service after the guarantee period, contact
your nearest Sunbeam service centre.
Your Sunbeam 12 Month Replacement
Guarantee naturally does not cover misuse
or negligent handling and normal wear and
tear.
For a complete list of Sunbeam’s authorised
service centres visit our website or call:
Australia
Similarly your 12 Month Replacement
Guarantee does not cover freight or any other
costs incurred in making a claim. Please
retain your receipt as proof of purchase.
1300 881 861
Units 5 & 6, 13 Lord Street
Botany NSW 2019 Australia
The benefits given to you by this guarantee
are in addition to your other rights and
remedies under any laws which relate to the
appliance.
New Zealand
0800 786 232
26 Vestey Drive, Mt Wellington
Auckland, New Zealand
Our goods come with guarantees that cannot
be excluded under the Australian Consumer
Law and under the New Zealand Consumer
Guarantees Act.
Need help with your appliance?
Contact our customer service team or visit
our website for information and tips on
getting the most from your appliance.
In Australia
Or call 1300 881 861
In New Zealand
Or call 0800 786 232
is a registered trademark.
Made in China.
Due to minor changes in design or otherwise,
the product may differ from the one shown in this leaflet.
© Copyright. Sunbeam Corporation Limited 2011.
ABN 45 000 006 771
Units 5 & 6, 13 Lord Street
Botany NSW 2019 Australia
Unit 3, Building D
26 Vestey Drive
Mt Wellington Auckland
New Zealand
Sunbeam Corporation is a division of GUD Holdings Ltd.
07/11
|