Sunbeam Electric Heater HE4200 User Manual

Convection Panel Heater  
2200 Watt  
Instruction Booklet  
HE4200  
Please read these instructions carefully  
and retain for future reference.  
 
Contents  
Sunbeam’s Safety Precautions  
Safety precautions for your Heater  
Features of your Convection Panel Heater  
Using your Convection Panel Heater  
To attach the feet with wheels  
Troubleshooting Guide  
2
3
4
6
7
8
8
Care and Cleaning  
Important instructions – retain for  
future use.  
1
 
Sunbeam’s Safety Precautions  
Sunbeam is very safety conscious when  
designing and manufacturing consumer products,  
but it is essential that the product user also  
exercise care when using an electrical appliance.  
Listed below are precautions which are essential  
for the safe use of an electrical appliance:  
• Read carefully and save all the instructions  
provided with an appliance.  
• Do not use an appliance for any purpose  
other than its intended use.  
• Do not place an appliance on or near a hot gas  
flame, electric element or on a heated oven.  
• Do not place on top of any other appliance.  
• Do not let the power cord of an appliance hang  
over the edge of a table or bench top or touch  
any hot surface.  
• Always turn the power off at the power outlet  
before you insert or remove a plug. Remove  
by grasping the plug - do not pull on the cord.  
Turn the power off and remove the plug  
when the appliance is not in use and  
before cleaning.  
• Do not use your appliance with an extension  
cord unless this cord has been checked  
and tested by a qualified technician or  
service person.  
• Always use your appliance from a power  
outlet of the voltage (A.C. only) marked  
on the appliance.  
• This appliance is not intended for use by  
persons (including children) with reduced  
physical, sensory or mental capabilities, or  
lack of experience and knowledge, unless they  
have been given supervision or instruction  
concerning use of the appliance by a person  
responsible for their safety.  
• Do not operate any electrical appliance with  
a damaged cord or after the appliance has  
been damaged in any manner. If damage is  
suspected, return the appliance to the nearest  
Sunbeam Appointed Service Centre  
for examination, repair or adjustment.  
• For additional protection, Sunbeam  
recommend the use of a residual current  
device (RCD) with a tripping current not  
exceeding 30mA in the electrical circuit  
supplying power to your appliances.  
• Do not immerse the appliance in water  
or any other liquid unless recommended.  
• Appliances are not intended to be operated  
by means of an external timer or separate  
remote control system.  
• This appliance is intended to be used in  
household and similar applications such  
as: staff kitchen areas in shops, offices and  
other working environments; farm houses; by  
clients in hotels, motels and other residential  
type environments; bed and breakfast type  
environments.  
• Children should be supervised to ensure that  
they do not play with the appliance.  
• The temperature of accessible surfaces may be  
high when the appliance is operating.  
If you have any concerns regarding the performance and use of your appliance,  
Ensure the above safety precautions are understood.  
2
 
Safety Precautions For Your Heater  
SAFETY PRECAUTIONS FOR YOUR  
• Do not locate the heater immediately below a  
SUNBEAM CONvECTION PANEL hEATER.  
socket outlet.  
• This heater becomes hot during use. To avoid  
burns, do not let bare skin touch hot surfaces.  
If provided, use handles when moving this  
heater. Keep combustible materials such as  
furniture, pillows, bedding, papers, clothes and  
curtains at least 1metre away from the front of  
the heater and keep them away from the sides  
and rear.  
• Do not use this heater in the immediate  
surroundings of a bath, shower, laundry area or  
swimming pool.  
• Do not insert or allow foreign objects to enter  
any ventilation or exhaust openings as this may  
cause electric shock or fire and damage to the  
heater.  
To prevent possible fire, do not block air  
intakes or exhaust in any manner. Do not use  
on soft surfaces, such as beds, where opening  
may become blocked.  
• Extreme caution is necessary when any heater  
is used by or near children or invalids and  
whenever the heater is left unattended.  
To prevent overheating, do not cover the heater.  
• Always unplug the heater when not in use.  
• Do not use outdoors.  
• A heater has hot and arcing or sparking parts  
inside. Do not use it in areas where petrol,  
paint or flammable liquids are used or stored.  
• If the appliance overheats, for example due to  
the air inlet or outlet grilles being accidentally  
blocked. The element automatically  
de-energizes until the heater cools down.  
As an added precaution we recommend  
unplugging the heater.  
• Do not run the cord of the heater under  
carpeting. Do not cover the cord with throw  
rugs, runners or other floor coverings. Arrange  
the cord away from traffic areas to avoid a  
tripping hazard.  
3
 
Features of your Sunbeam  
Convection Panel Heater  
Slimline Design  
Pressed metal exterior  
Solid stable feet  
Wheels for easy maneuverability  
4
 
Thermostat controlled operation  
2 Heat and off setting  
Thermostat indicator light  
5
 
Using your Sunbeam Convection  
Panel Heater  
1.Place the heater on a flat level surface.  
Ensure that the heater is at least 1 metre  
away from furniture and curtains.  
6.Before storing your heater we recommend  
allowing the heater to cool down.  
NOTE: Before first use we recommend  
switching your heater on in a well ventilated  
area to disperse any vapours that have  
resulted during the production of this heater.  
Once cleared, this will not reoccur.  
2.Insert the plug into a 230-240 power outlet.  
Turn the power on.  
3.Press the switch to either LOW or hIGh  
setting.  
4.To achieve your desired room temperature  
use the Thermostat Control dial which  
adjusts the temperature.  
5.To turn off your heater, switch your heat  
setting button to the 0 position.  
6
 
To attach the feet with wheels  
The hE4200 has the feet with wheels and screws stored within the box, separate to the body.  
Mounting  
Locating  
Screw  
holes  
slots  
Positioning is only possible in the one orientation, either foot can be used at either end.  
Attaching the feet with wheels  
1.Carefully position the heater upside down on a carpeted area.  
2.Use the screws provided to fix the feet with wheels to the body at either end of the heater  
using a screwdriver.  
7
 
Troubleshooting Guide  
1.If your heater fails to operate, check the  
following:  
- Check that the thermostat is not set too low.  
Turn the dial clockwise to adjust the electric  
thermostat. Until the heater restarts.  
- Make sure the electrical outlet or circuit  
breaker is working..  
- Check for obstructions, if obstructions are  
present, the heater may have gone over  
temperature. If this is the case turn off  
the heater at the power outlet, remove the  
obstructions and wait for the heater to cool  
before turning the heater back on.  
Care and Cleaning  
Ensure that the heater is switched off and  
disconnected from the power outlet before  
cleaning.  
Do not use harsh or abrasive cleaners to  
clean your heater, as these will damage the  
surface.  
Carefully wipe the exterior of the heater with  
a soft damp cloth and dry thoroughly with a  
dry cloth.  
When not in use store the heater in a cool  
dry place.  
Over time, dust may accumulate on the front  
grille. This can be removed by wiping with a  
damp cloth, or by carefully going across the  
grille with a vacuum cleaner or hand held  
vacuum.  
8
 
2 Year Replacement Guarantee  
In the unlikely event that this appliance develops any malfunction  
within 2 years of purchase (3 months commercial use) due to  
faulty materials or manufacture, we will replace it for you  
free of charge.  
Should you experience any difficulties with  
your appliance, please phone our customer  
service line for advice on 1300 881 861 in  
Australia, or 0800 786 232 in New Zealand.  
Alternatively, you can send a written claim  
to Sunbeam at the address listed below.  
On receipt of your claim, Sunbeam will  
seek to resolve your difficulties or, if the  
appliance is defective, advise you on how  
to obtain a replacement or refund.  
In Australia you are entitled to a  
replacement or refund for a major failure and  
for compensation for any other reasonably  
foreseeable loss or damage. You are also  
entitled to have the goods repaired or  
replaced if the goods fail to be of acceptable  
quality and the failure does not amount to  
a major failure.  
Should your appliance require repair or  
service after the guarantee period, contact  
your nearest Sunbeam service centre.  
Your Sunbeam 2 Year Replacement  
Guarantee naturally does not cover misuse  
or negligent handling and normal wear and  
tear.  
For a complete list of Sunbeam’s authorised  
service centres visit our website or call:  
Australia  
Similarly your 2 Year Replacement Guarantee  
does not cover freight or any other costs  
incurred in making a claim. Please retain  
your receipt as proof of purchase.  
1300 881 861  
Units 5 & 6, 13 Lord Street  
Botany NSW 2019 Australia  
The benefits given to you by this guarantee  
are in addition to your other rights and  
remedies under any laws which relate to the  
appliance.  
New Zealand  
0800 786 232  
26 Vestey Drive, Mt Wellington  
Auckland, New Zealand  
Our goods come with guarantees that cannot  
be excluded under the Australian Consumer  
Law and under the New Zealand Consumer  
Guarantees Act.  
 
Need help with your appliance?  
Contact our customer service team or visit  
our website for information and tips on  
getting the most from your appliance.  
In Australia  
Or call 1300 881 861  
In New Zealand  
Or call 0800 786 232  
is a registered trademark.  
Made in China.  
Due to minor changes in design or otherwise,  
the product may differ from the one shown in this leaflet.  
© Copyright. Sunbeam Corporation Limited 2011.  
ABN 45 000 006 771  
Units 5 & 6, 13 Lord Street  
Botany NSW 2019 Australia  
Unit 3, Building D  
26 Vestey Drive  
Mt Wellington Auckland  
New Zealand  
Sunbeam Corporation is a division of GUD Holdings Ltd.  
11/11  
 

Sharp CRT Television 36C530 User Manual
Shure Satellite Radio P4T User Manual
Sony Camcorder PEGA MSC1 User Manual
Sony Camera Accessories APK WA User Manual
Sony Headphones PFR V1 User Manual
Sony MP3 Player CFD S22 User Manual
Sony Projector ES7 User Manual
SRS Labs Projector CP X809 User Manual
Stanley Black Decker Grinder FG10 User Manual
Stiga Trimmer 13 6241 43 User Manual