Sunbeam Electric Shaver MG6500 User Manual
®
X-Press  
CordlessBeardTrimmer&Shaper  
Instruction Booklet  
MG6500  
Please read these instructions carefully  
and retain for future reference.  
 
Sunbeam’s Safety  
Precautions  
SAFETY PRECAUTIONS FOR YOUR CORDLESS BEARD  
TRIMMER & SHAPER  
• Keep out of the reach of children  
• For household use only  
• Never touch the power plug with wet hands when plugging in or  
unplugging  
• If the appliance is used with an extension cord or electrical  
portable outlet device, they should be positioned so they are not  
subject to splashing or moisture  
• Do not place the blades in water or any other liquid.  
• Do not use the appliance with a broken or damaged attachment  
• Do not attempt to sharpen the blades  
• This appliance is not intended for use by young children or  
infirm persons unless they have been adequately supervised by  
a responsible adult to ensure that they can use the appliance  
safely.  
If you have any concerns regarding the performance and use of  
your appliance, please visit www.sunbeam.com.au or contact  
the Sunbeam Consumer Service Line.  
Ensure the above safety precautions are understood.  
3
 
 
Sunbeam’s Safety  
Precautions  
Sunbeam are very safety conscious when  
designing and manufacturing consumer products, but it is essential  
that the product user also exercise care when using an electrical  
appliance. Listed below are precautions which are essential for the  
safe use of an electrical appliance:  
• Read carefully and save all the instructions provided with an  
appliance.  
• Always turn the power off at the power outlet before you insert  
or remove a plug. Remove  
by grasping the plug - do not pull on the cord.  
• Turn the power off and remove the plug  
when the appliance is not in use and  
before cleaning.  
• Do not use your appliance with an extension cord unless this  
cord has been checked  
and tested by a qualified technician or  
service person.  
• Always use your appliance from a power  
outlet of the voltage (A.C. only) marked  
on the appliance.  
• This appliance is not intended for use by young children or  
infirm persons unless they have been adequately supervised by  
a responsible adult to ensure that they can use the appliance  
safely.  
• Young children should be supervised to ensure that they do not  
play with the appliance.  
4
 
Sunbeam’s Safety Precautions continued  
• Never leave an appliance unattended while  
in use.  
• Do not use an appliance for any purpose  
other than its intended use.  
• Do not place an appliance on or near a hot gas flame, electric  
element or on a heated oven. Do not place on top of any other  
appliance.  
• Do not let the power cord of an appliance hang over the edge  
of a table or bench top or touch any hot surface.  
• Do not operate any electrical appliance with a damaged cord  
or after the appliance has been damaged in any manner. If  
damage is suspected, return the appliance to the nearest  
Sunbeam Appointed Service Centre  
for examination, repair or adjustment.  
• For additional protection, Sunbeam recommend the use of  
a residual current device (RCD) with a tripping current not  
exceeding 30mA in the electrical circuit supplying power to  
your appliances.  
• Do not immerse the appliance in water  
or any other liquid unless recommended.  
5
 
Features of yourCordless  
Beard Trimmer&Shaper  
Beard & moustache trimmer  
On / off switch  
Storage stand / charging  
base  
6
 
 
Adjustable cutting guide  
Shaping blade  
Nose & ear hair trimmer  
Shaving Head  
Moustache comb  
Cleaning brush  
Oil  
Adaptor  
7
 
Using your Cordless  
BeardTrimmer&Shaper  
Using for the first time  
• The appliance must be fully charged before using for the  
first time.  
• To reach the optimum recharge capacity, the batteries  
should be charged for 8.5 hours. Do not charge for longer  
than this time.  
• Ensure that the Beard Trimmer & Shaper is switched off by  
pushing down the on / off switch.  
• Insert the charger lead into the charging stand and place the  
Beard Trimmer & Shaper firmly into the slot location  
• Plug the adaptor into a suitable mains outlet and switch on.  
• The red light on the appliance will light up and will switch  
to green when charging is completed.  
• The Beard Trimmer & Shaper will work for approximately 35  
minutes on full charge.  
• Recharging after each use is not needed if the 35 minute  
working period has not been fully used.  
• It is not possible to use this appliance when the adaptor is  
plugged into the mains.  
Note: Do not charge for longer than the recommended  
time of 8.5 hours.  
Using the nose & ear hair trimmer  
• Attach the nose hair trimmer attachment by placing on the  
unit and turning clockwise until it clicks into place.  
8
 
 
Using your Cordless Beard Trimmer &  
Shaper continued  
• Switch the appliance on.  
• Insert the appliance into the ear or nose but no more than  
6mm.  
• Rotate in a circular movement.  
• The appliance can also be used to trim stray eyebrow hairs.  
Move the appliance slowly and carefully keeping the unit  
away from the eye socket.  
• Remove all attachments by twisting anticlockwise and  
pulling off.  
Using the beard & sideburn trimmer  
• Attach the beard & sideburn trimmer attachment by placing  
on the unit and turning clockwise until it clicks into place.  
• Choose the length of beard or moustache you require and  
attach the appropriate comb by placing over the head of the  
attachment and clicking into place.  
• Move the switch on the comb to the required length. We  
recommend that you start with a longer length and then  
move to a shorter cut if necessary.  
• Ensure that your beard or moustache is dry and using the  
comb provided, make sure that all the hairs are facing the  
same direction.  
• Switch the appliance on.  
• Start under the chin and follow your jaw line moving in an  
upward direction.  
9
 
Using your Cordless Beard Trimmer &  
Shaper continued  
• This attachment can also be used to trim sideburns.  
Using the beard shaping blade  
• Attach the beard shaping attachment by placing on the unit  
and turning clockwise until it clicks into place.  
• Switch the appliance on.  
• Use this blade to create smooth lines and edges or your own  
unique beard design.  
Using the shaver head  
• Attach the shaver head attachment by placing on the unit  
and turning clockwise until it clicks into place.  
• Switch the appliance on.  
• Use to tidy the back of the neck and to create defined beard  
edges around the jaw line.  
Help Line  
If you have any additional questions about using the Cordless  
Beard Trimmer & Shaper, please call the Sunbeam help line in  
Australia on 1800 025 059.  
In New Zealand, please call 0800 786 232.  
10  
 
Battery Disposal  
At the end of the product’s life, the Cordless Beard Trimmer  
& Shaper must be returned to a Sunbeam Service Centre for  
correct disposal of the Nimh rechargeable battery.  
The battery must be removed from the appliance before it is  
scrapped. The battery is to be disposed of safely.  
Care and Cleaning  
• Do not immerse the appliance in water or any other liquid.  
• The appliance can be wiped with a cloth dampened in water  
and a mild detergent. Rinse and dry thoroughly.  
• Remove hair from the blades after each use with the  
cleaning brush supplied.  
• The adjustable cutting guide can be washed under a running  
tap.  
• Do not rinse the entire unit in water – only the adjustable  
cutting guide.  
• Store in a cool, dry place.  
• The blades of the attachment must be oiled regularly to  
maintain their performance. Wipe the blades with a few  
drops of the oil supplied and remove any excess before  
using.  
11  
 
 
Consumer Hotline  
Australia  
1800 025 059  
New Zealand  
0800 786 232  
www.sunbeam.com.au  
‘Sunbeam’, is a registered trademark of Sunbeam  
Corporation.  
Made in China. Due to minor changes in design or  
otherwise, the product may differ from the one shown  
in this leaflet. Backed by Sunbeam's 2 Year Replacement  
Guarantee and National Service Network.  
© Copyright. SUNBEAM CORPORATION LIMITED 2005.  
(INCORPORATED IN N.S.W.) A.C.N. 000 006 771  
Sunbeam Corporation is a division of GUD Holdings Ltd.  
For more information or advice on this or any other  
Sunbeam appliance, visit www.sunbeam.com.au or  
contact the Sunbeam Consumer Service Line.  
Australia 1800 025 059  
New Zealand 0800 786 232.  
06/05  
is a registered Trademark of Sunbeam  
Corporation Limited. ACN 000 006 771.  
© Sunbeam Corporation Limited 2005.  
 

Sennheiser Microphone SKM 945 User Manual
Server Technology Switch CW 8H User Manual
Shoprider Mobility Aid 888WNLL User Manual
Soleus Air Air Conditioner SG TTW 10HC User Manual
Sony Car Satellite TV System BKM FW50 User Manual
Sony MP3 Player D FJ787 User Manual
Sony MP3 Player TCM 16 User Manual
Sony VCR SLV X847ML User Manual
StarTechcom Computer Drive S2510BMU33 User Manual
Symphonic DVD Player WF104 User Manual