Sunbeam Hot Beverage Maker KE8200 B User Manual

Instruction Booklet  
DownloadPlf  
e
r
a
o
s
m
e re  
W
ad  
w
t
w
he.Sse  
o
i
m
nst  
a
ru  
n
c
u
tiaonls  
s
.
c
c
a
o
r
m
efu  
.
l
Aly  
l
a
l
n
M
d
a
re  
n
ta  
u
i
a
n
l
f
s
orSfu  
e
t
a
ur  
r
e
c
r
h
efAernen  
d
c
D
e
ownload.  
KE8200/B  
Sunbeam’s Safety Precautions  
SAFETY PRECAUTIONS FOR YOUR SUNBEAM  
PURE ELEMENTS KETTLE.  
• Boiling water will scald. Do not leave a boiling or  
hot kettle near or where children may touch it.  
• Do not leave the power cord near the edge of  
a bench top where children may touch or pull  
on it.  
• Always operate the kettle on a flat, level surface.  
• Always store excess cord in the storage facility  
underneath the power base.  
• Always ensure the lid is securely closed to endure  
correct operation of the kettle.  
• Always beware of steam being emitted from the  
spout or lid especially during refilling.  
• Do not move kettle while switched on.  
• Always turn the power off and unplug the cord  
while the kettle is NOT in use.  
• Do not use the kettle to heat anything other than  
water.  
• Never fill above the ‘max’ indication as hot water  
may be ejected.  
• Do not operate the kettle without water.  
• Your kettle must only be used with the power  
base supplied.  
Sunbeam is very safety conscious when  
designing and manufacturing consumer products,  
but it is essential that the product user also exercise  
care when using an electrical appliance. Listed  
below are precautions which are essential for the  
safe use of an electrical appliance:  
• Do not use an appliance for any purpose  
other than its intended use.  
• Do not place an appliance on or near a hot gas  
flame, electric element or on a heated oven.  
• Do not place on top of any other appliance.  
• Do not let the power cord of an appliance hang  
over the edge of a table or bench top or touch any  
hot surface.  
• Read carefully and save all the instructions  
provided with an appliance.  
• Always turn the power off at the power outlet  
before you insert or remove a plug. Remove by  
grasping the plug - do not pull on the cord.  
Turn the power off and remove the plug when the  
appliance is not in use and before cleaning.  
• Do not use your appliance with an extension cord  
unless this cord has been checked and tested by  
a qualified technician or service person.  
• Always use your appliance from a power outlet of  
the voltage (A.C. only) marked on the appliance.  
• This appliance is not intended for use by persons  
(including children) with reduced physical,  
sensory or mental capabilities, or lack of  
experience and knowledge, unless they have been  
given supervision or instruction concerning use  
of the appliance by a person responsible for their  
safety.  
• Do not operate any electrical appliance with a  
damaged cord or after the appliance has been  
damaged in any manner. If damage is suspected,  
return the appliance to the nearest Sunbeam  
Appointed Service Centre for examination, repair  
or adjustment.  
• For additional protection, Sunbeam recommend  
the use of a residual current device (RCD)  
with a tripping current not exceeding 30mA in  
the electrical circuit supplying power to your  
appliances.  
• Do not immerse the appliance in water or any  
other liquid unless recommended.  
• Appliances are not intended to be operated by  
means of an external timer or separate remote  
control system.  
• This appliance is intended to be used in  
household and similar applications such as: staff  
kitchen areas in shops, offices and other working  
environments; farm houses; by clients in hotels,  
motels and other residential type environments;  
bed and breakfast type environments.  
• Children should be supervised to ensure that they  
do not play with the appliance.  
• The temperature of accessible surfaces may be  
high when the appliance is operating.  
• Never leave an appliance unattended while  
in use.  
If you have any concerns regarding the performance and use of your appliance,  
Ensure the above safety precautions are understood.  
2
 
Features of your Sunbeam  
Pure Elements Kettle  
Two water gauge levels  
The full length water gauge indicates the  
volume of water in the kettle up to 1.3  
litres. The two gauges make the kettle  
convenient to use for both left and right  
handed users.  
2000 watt concealed element  
The 2000 watt element is concealed  
in the base of the kettle for longer  
life. The floor non-stick coated to reduced  
scale build up and allows  
for easy cleaning.  
Removable mesh filter  
Mesh filter keeps the water  
clean of any foreign matter and  
is removable for easy cleaning.  
3
 
3-Way Safety System.  
1 – Automatically switches the kettle off after boiling.  
2 – Cuts out for boil-dry production.  
3 – Shuts down in case of overheating.  
Handle activated hinged locking lid  
For ease of use the lid is activated  
by a single press of a button. The  
design is ideal for one-handed use and  
also locks shut to prevent accidental  
scalding.  
Neon on/off Switch with auto cut-out  
Lights up to indicate that the kettle  
is on and heating, and switches the  
kettle off automatically after boiling.  
Cordless power base with cord storage  
The cordless powerbase allows you to  
place the kettle in two positions and  
also features a storage compartment  
for any unwanted cord length.  
4
 
Usingyour Sunbeam  
Pure Elements Kettle  
Before using your kettle  
7.The kettle may be stored on the power  
base while not in use. The kettle will not  
re-boil until the ON/OFF switch is pressed  
downward.  
Note: Ensure the power is turned off at the  
power outlet when the kettle is not in use.  
Should you accidentally allow the kettle to  
operate without water, boil-dry protection  
will automatically switch it off. If this occurs,  
allow the kettle to cool before filling with  
cold water and re-boiling.  
It is recommended that you clean your kettle  
before use by filling the kettle with water,  
up to the maximum level indicator, boil and  
discard.  
Using your kettle  
1.To fill the kettle, remove it from the power  
base and lift the lid, by pressing the button  
at the top of the handle. Alternatively, the  
kettle may be filled through the pouring  
spout.  
2.Fill the kettle with the desired amount of  
water.  
Cord Storage Facility  
Excess cord can be stored by winding the  
cord around the storage facility underneath  
the power base.  
Note: Do not fill the kettle over the maximum  
level, as water may spill out of the spout  
when boiling.  
3.Push the lid closed firmly until it locks into  
position.  
4.Place the kettle on the power base and  
connect the plug into a 230/240 Volt AC  
power outlet. Turn the power ON.  
5.Press the ON/OFF button downwards at the  
base of the handle. The power indicator  
light will illuminate to indicate the kettle  
is heating. The kettle will switch off  
Power base with cord wrap  
automatically once the water has boiled.  
Note: Ensure that the ON/OFF switch is clear  
of obstructions and the lid is firmly closed.  
The kettle will not turn off if the ON/OFF  
switch is constrained or if the lid is left open.  
Do not remove the kettle from the power base  
while in use.  
6.Lift the kettle from the power base and  
pour the water.  
Note: Use caution when pouring the water  
from your kettle, as boiling water will scald.  
5
 
Sunbeam’s 3-Way  
Safety System  
Safety is a major consideration in the  
design of a Sunbeam kettle. This is why we  
have developed our 3-Way Safety System,  
which ensures that your kettle will:  
3.Shut-down in case of overheating.  
In the event of overheating, the kettle will  
automatically shut down to prevent further  
damage.  
1.Automatically switch off after boiling.  
For convenience, safety and energy  
efficiency, your Sunbeam kettle will  
automatically switch off after boiling.  
2.Cut-out for boil-dry protection.  
If the kettle is operated without water, it  
will automatically cut-out, preventing any  
damage to the element.  
If this occurs, allow the kettle to cool  
before filling with cold water and  
re-boiling.  
6
 
Care and cleaning  
Always disconnect the kettle from the power  
outlet before cleaning.  
Never immerse any part of the kettle in  
water, or allow moisture to come into contact  
with the kettle switch area, cord or power  
base.  
To clean the kettle exterior  
The kettle surface may be wiped over with  
a damp cloth and polished with a soft dry  
cloth.  
CAUTION: Do not use chemicals, steel wool, or  
abrasive cleaners to clean the outside of the  
kettle, as these will scratch the surface.  
Removal of mineral deposits.  
Mineral deposits in tap water may cause the  
interior of the water gauge to discolour. To  
remove this build-up, use Sunbeam Liquid  
Descaler, a simple to use, non-toxic cleaner  
available from Sunbeam Appointed  
To clean the mesh filter  
Press the button on the handle to open  
the hinged lid. Grasp the top of the mesh  
filter and pull upwards to remove. Wash in  
warm soapy water and dry thoroughly before  
replacing in the kettle.  
Service Agents.  
Alternatively:  
1.Fill the kettle with 3 cups of white vinegar  
and the remainder with water and allow to  
stand overnight. DO NOT BOIL.  
2.Empty the solution from the kettle. Any  
stains remaining inside the spout can be  
removed by rubbing with a damp cloth. Fill  
the kettle with clean water, bring to boil  
and then discard the water. Repeat and the  
kettle will then be ready to use.  
7
 
Notes  
 
Notes  
 
12 Month Replacement Guarantee  
In the unlikely event that this appliance develops any malfunction  
within 12 months of purchase (3 months commercial use) due  
to faulty materials or manufacture, we will replace it for you free  
of charge.  
Should you experience any difficulties with  
your appliance, please phone our customer  
service line for advice on 1300 881 861 in  
Australia, or 0800 786 232 in New Zealand.  
Alternatively, you can send a written claim  
to Sunbeam at the address listed below.  
On receipt of your claim, Sunbeam will  
seek to resolve your difficulties or, if the  
appliance is defective, advise you on how  
to obtain a replacement or refund.  
In Australia you are entitled to a  
replacement or refund for a major failure and  
for compensation for any other reasonably  
foreseeable loss or damage. You are also  
entitled to have the goods repaired or  
replaced if the goods fail to be of acceptable  
quality and the failure does not amount to  
a major failure.  
Should your appliance require repair or  
service after the guarantee period, contact  
your nearest Sunbeam service centre.  
Your Sunbeam 12 Month Replacement  
Guarantee naturally does not cover misuse  
or negligent handling and normal wear and  
tear.  
For a complete list of Sunbeam’s authorised  
service centres visit our website or call:  
Australia  
Similarly your 12 Month Replacement  
Guarantee does not cover freight or any other  
costs incurred in making a claim. Please  
retain your receipt as proof of purchase.  
1300 881 861  
Units 5 & 6, 13 Lord Street  
Botany NSW 2019 Australia  
The benefits given to you by this guarantee  
are in addition to your other rights and  
remedies under any laws which relate to the  
appliance.  
New Zealand  
0800 786 232  
26 Vestey Drive, Mt Wellington  
Auckland, New Zealand  
Our goods come with guarantees that cannot  
be excluded under the Australian Consumer  
Law and under the New Zealand Consumer  
Guarantees Act.  
 
Need help with your appliance?  
Contact our customer service team or visit  
our website for information and tips on  
getting the most from your appliance.  
In Australia  
Or call 1300 881 861  
In New Zealand  
Or call 0800 786 232  
is a registered trademark.  
‘Pure Elements’ is a trademark of Sunbeam Corporation.  
Made in China.  
Due to minor changes in design or otherwise,  
the product may differ from the one shown in this leaflet.  
© Copyright. Sunbeam Corporation Limited 2010.  
ABN 45 000 006 771  
Sunbeam Corporation is a division of GUD Holdings Ltd.  
Units 5 & 6, 13 Lord Street  
Botany NSW 2019 Australia  
Unit 3, Building D  
26 Vestey Drive  
Mt Wellington Auckland  
New Zealand  
Sunbeam Corporation is a division of GUD Holdings Ltd.  
08/11  
 

Sharp Air Cleaner FP R30CX User Manual
Sharp Air Cleaner KC C150U User Manual
Sharp All in One Printer AR BC320 User Manual
Sharp Calculator EL 1750PIII User Manual
Sony Cassette Player WM FX661 User Manual
Sony Cordless Telephone SPP ID976 User Manual
Sony Microcassette Recorder 427 User Manual
Sony PDAs Smartphones VCL 04HS User Manual
Sony Speaker System CMT EP305 User Manual
Stiga Lawn Mower 11 5234 23 User Manual