Therapeutics
Pedicure Foot
Spa
Instruction Booklet
FB6500
Please read these instructions carefully
and retain for future reference.
Sunbeam’s Safety Precautions
SAFETY PRECAUTIONS FOR YOUR PEDICURE FOOT SPA.
Please read this booklet carefully before you start to use your Pedicure Foot Spa. It will enable
you to get the most out of your new product and to safely enjoy its many benefits. Please retain
this booklet for future reference
1. Diabetics and people with heart conditions
or circulation problems must consult their
health care practitioner before use.
7. Dry your hands thoroughly before
connecting or disconnecting the plug from
the power outlet or switching any switch.
2. If you are pregnant please consult your
health care practitioner before use.
8. Do not stand up while using the product.
9. Do not place any objects inside the
appliance.
3. If you suffer from any problems with your
legs or feet such as varicose veins, please
consult your health care practitioner before
use.
10. Do not use the appliance while sleeping or if
you are feeling drowsy.
11. The infra-red panel will get hot. Persons
insensitive to heat must be careful when
using this setting.
4. Do not use if your feet are swollen or
inflamed or if you have any skin irritations.
5. Discontinue use immediately if you feel any
discomfort or if pain or irritation occurs.
12. Do not use the appliance for more than 20
minutes. Switch off and allow to cool down
before using again or storing.
6. Do not connect or disconnect the plug from
the power outlet while your feet are in the
water.
If you have any concerns regarding the performance and use of your appliance, please ring our
Customer Service Line on 1800 025 059. In New Zealand - contact Sunbeam on 09 912 0747.
Ensure the above safety precautions are understood.
2
Sunbeam’s Safety Precautions
SAFETY PRECAUTIONS FOR ALL ELECTRICAL APPLIANCES
Sunbeam are very safety conscious when designing and manufacturing consumer products,
but it is essential that the product user also exercises care when using an electrical appliance.
Listed below are precautions which are essential for the safe use of an electrical appliance:
1. Read carefully and save all the instructions
provided with an appliance.
10.Do not let the power cord of an appliance
hang over the edge of a table or bench top
or touch any hot surface.
2. Always turn the power off at the power
outlet before you insert or remove a plug.
Remove by grasping the plug - do not pull
on the cord.
11. For safety reasons and to avoid
maintenance by unskilled persons, some
appliances are ‘sealed’ using tamperproof
screws. Such appliances should always be
returned to the nearest Sunbeam Appointed
Service Centre for adjustment or repair if
required.
3. Turn the power off and remove the plug
when the appliance is not in use and before
cleaning.
4. Do not use your appliance with an extension
cord unless this cord has been checked
and tested by a qualified technician or
service person.
12. Do not operate any electrical appliance with
a damaged cord or after the appliance has
been dropped or damaged in any manner. If
damage is suspected, return the appliance
to the nearest Sunbeam Appointed Service
Centre for examination, repair or adjustment.
5. Always use your appliance from a power
outlet of the voltage (A.C. only) marked on
the appliance.
13. For additional protection, Sunbeam
recommend the use of a residual current
device (RCD) with a tripping current not
exceeding 30mA in the electrical circuit
supplying power to your appliances.
6. Close supervision is necessary when your
appliance is being used near children or
infirm persons.
7. Young children should be supervised to
ensure that they do not play with the
appliance.
14. Do not immerse the appliance in water or
any other liquid unless recommended.
8. Do not use an appliance for any purpose
other than its intended use.
9. Do not place an appliance on or near a hot
gas flame, electric element or on a heated
oven. Do not place on top of any other
appliance.
3
Features of your Pedicure
Foot Spa
Control Dial
Anti Splash Cover
Massage Nodes
Rollers
4 attachments –
cleansing brush, pumice stone,
massage and reflexology
4
Control Panel
Storage compartment
Pedicure centre
Infra-red panel
5
Using Your Pedicure Foot Spa
1. Ensure that the control dial is in the ‘O’ off
position.
Setting 2 –Massage, Heat, Infra-red heat
& Bubbles
2. Place the product on a firm, level floor
This setting will also make the water bubble
for an invigorating treatment. Use all these
features when feet are tired and sore.
3. Place a chair behind the unit and adjust its
position until you can sit comfortably with
your feet inside the appliance (without
water).
Setting 3 – Bubbles & Heat
Using the Pedicure Centre
4. Place a towel within easy reach to dry your
feet afterwards.
Push one of the attachments onto the fitting
on the pedicure centre. Press lightly with
your foot to activate. Maintain pressure
whilst moving the attachment over the sole
of the foot. Use the Cleansing Brush
attachment to gently cleanse the foot. Use
the Pumice Stone attachment to rub away
hard skin which will have been softened by
the water. Use the Massage attachment to
massage all over your foot. Use the
5. Using a large jug, fill the foot spa with water.
Do not fill above the maximum level
indicated.
6. Do not use hot water as this will make your
feet sweat.
7. Insert the plug into a 230-240 volt power
outlet and turn on.
Reflexology Attachment to massage a
particular part of the foot. Lift your foot from
the unit to stop it rotating. Lift the
8. Sit in the chair and place your feet in the
appliance.
9. Turn the switch to the setting you wish to
use –
attachment straight up to remove it.
10. Do not use the product for more than 20
minutes.
Setting 1 – Massage, Heat & Infra-red
heat
11. When you have finished using the
appliance, return the switch to the ‘O’ off
position and remove your feet from the unit
and dry thoroughly.
When using this setting, the appliance will
maintain the temperature of the water which
you have added. It will not heat cold water.
To increase the intensity of the massage,
move your feet backwards and forwards
12. Turn off power outlet and remove plug.
over the rollers in the base of the appliance. 13. Discard the water.
If the rollers are not required simply remove
and replace with the plain insets. Place the
sole of your foot on the infra-red panel to
soothe and ease aches and pains. This
also helps with the absorption of any
treatment creams.
6
Care and Cleaning
1. Turn the control dial to the ‘O’ off position
5. The inside of the appliance, the attachments
and the exterior walls can be wiped over
with a cloth dampened in water and a mild
detergent. Then rinse and dry
2. Turn the power off and remove the plug from
the power outlet.
3. Rinse the inside of the appliance with warm
water.
6. The attachments can be washed in a mild
detergent. Dry thoroughly before using
again. Store in the storage compartment
4. Do not immerse the appliance in water or
any other liquid
Help Line
If you have any additional questions about using the Pedicure Foot Spa please call the
Sunbeam help line in Australia on 1 800 025 059. In New Zealand please call 09 912 0747.
7
Sunbeam is a registered trademark. Made in China. Due to minor
changes in design or otherwise, the product may differ from the
one shown in this leaflet. Approved by the appropriate Electrical
Regulatory Authorities. Backed by Sunbeam‘s 12 Month
Replacement Guarantee and National Service Network.
For more information or advice on this or any other
or contact the Sunbeam Consumer Service Line.
Australia 1800 025 059
New Zealand (09) 912 0747.
© Copyright. SUNBEAM CORPORATION LIMITED 2003.
(INCORPORATED IN N.S.W.) A.C.N. 000 006 771
Sunbeam Corporation is a division of GUD Holdings Ltd.
9
Therapeutics
Consumer Hotline
Australia
1800 025 059
New Zealand
(09) 912 0747
is a registered Trademark of Sunbeam
Corporation Limited. ACN 000 006 771.
© Sunbeam Corporation Limited 2003.
|