Sunbeam Styling Iron WD5800 User Manual

Salon Technique®  
Wet to Dry Straightener with  
Ionic Technology  
Instruction Booklet  
WD5800 / WD5810  
 
Please read these instructions carefully and retain for future reference.  
Sunbeam’s Safety Precautions  
SAFETY PRECAUTIONS  
FOR YOUR WET TO DRY  
STRAIGHTENER WITH IONIC  
TECHNOLOGY  
• This hairstyler must not come  
into contact with water or any  
other liquid.  
• Always switch off your  
hairstyler at the power outlet  
and remove the plug when  
not in use.  
use as the proximity of water  
presents a hazard even when  
the unit is switched off.  
• Do not touch the heating  
plates when in use as they  
will become extremely hot.  
• Do not use this hairstyler if  
hair is treated with flammable  
products such as hair spray.  
• Do not use on hair extensions.  
• This styler reaches very high  
temperatures very quickly.  
Once the styler is plugged in  
and switched on, DO NOT  
touch with your fingers.  
• Do not place on a soft surface  
such as a bed or pillow.  
During use, rest the styler on  
a hard, flat surface.  
• Do not store or use your  
hairstyler near tubs, basins,  
baths or other vessels  
containing water or any other  
liquid.  
• When the hairstyler is used in  
the bathroom, unplug it after  
DO NOT allow the styler to  
touch the skin.  
WARNING – The vent holes  
must be held away from the  
face and head as the steam  
escaping through them is  
very hot.  
If you have any concerns regarding the performance and  
contact the Sunbeam Consumer Service Line.  
 
Ensure the above safety precautions are understood.  
1
 
Sunbeam’s Safety Precautions  
Sunbeam are very safety  
• Do not use your appliance  
with an extension cord  
unless this cord has been  
checked and tested by a  
qualified technician or  
service person.  
• Always use your appliance  
from a power outlet of the  
voltage (A.C. only) marked  
on the appliance.  
conscious when designing  
and manufacturing consumer  
products, but it is essential  
that the product user also  
exercise care when using an  
electrical appliance. Listed  
below are precautions which  
are essential for the safe use  
of an electrical appliance:  
• Read carefully and save all  
the instructions provided  
with an appliance.  
• Always turn the power off  
at the power outlet before  
you insert or remove a plug.  
Remove by grasping the  
plug – do not pull on the  
cord.  
• Turn the power off and  
remove the plug when the  
appliance is not in use and  
before cleaning.  
• This appliance is not  
intended for use by young  
children or infirm persons  
unless they have been  
adequately supervised  
by a responsible adult to  
ensure that they can use the  
appliance safely.  
• Never leave an appliance  
unattended while in use.  
• Young children should be  
supervised to ensure that  
they do not play with the  
appliance.  
 
2
Sunbeam’s Safety Precautions continued  
• Do not use an appliance  
for any purpose other than  
its intended use.  
• Do not place an appliance  
on or near a hot gas  
flame, electric element or  
on a heated oven. Do not  
place on top of any other  
appliance.  
• Do not let the power cord  
of an appliance hang over  
the edge of a table or  
bench top or touch any  
hot surface.  
• For safety reasons and  
to avoid maintenance by  
unskilled persons, some  
appliances are ‘sealed’  
using tamperproof screws.  
Such appliances should  
always be returned to  
the nearest Sunbeam  
Appointed Service Centre  
for adjustment or repair if  
required.  
• Do not operate any  
electrical appliance with  
a damaged cord or after  
the appliance has been  
dropped or damaged in  
any manner. If damage  
is suspected, return the  
appliance to the nearest  
Sunbeam Appointed  
Service Centre for  
examination, repair or  
adjustment.  
• For additional protection,  
Sunbeam recommend  
the use of a residual  
current device (RCD) with  
a tripping current not  
exceeding 30mA in the  
electrical circuit supplying  
power to your appliances.  
• Do not immerse the  
appliance in water or  
any other liquid unless  
recommended.  
 
3
Features of your Wet toDryStrai  
LED indicator  
Variable temperature  
control switch  
Finger rest  
Steam vents  
Ceramic  
straightening  
plates  
Negative ion vents  
Spring loaded plates  
Rounded  
edges  
 
4
 
aightener with Ionic Technology  
WD5810 – Larger heating plates  
Handle  
Swivel cord with  
3 metre salon length cord  
Lock  
Ion indicator  
Ceramic heating elements  
 
5
Using your Wet to Dry  
Straightener with Ionic  
Technology  
• Before you start to style  
your hair, comb through so  
that there are no tangles.  
• For best results, towel dry  
hair. Do not use on dripping  
wet hair.  
• Plug in to a suitable supply  
and switch on. The top  
neon green light will come  
on. This is the hottest  
approximately 5cms wide  
and comb or brush it  
through. Working from  
root to the ends, place the  
section between the plates  
and squeeze the handle  
shut. Be careful not to  
touch your skin.  
• Hold the styler in place for  
3 to 5 seconds depending  
on your hair type (3  
seconds for fine hair and  
up to 5 seconds for thicker  
hair).  
• Once the hair is heated,  
carefully slide the styler  
along the direction of  
separated hair making sure  
that the hair is heated and  
straightened all the way to  
the ends.  
setting at 200 degrees.  
• There is no need to pre heat  
the styler. The styler will get  
very hot very quickly so do  
not touch with your fingers.  
• Apply a styling lotion.  
We recommend PPS  
professional products.  
• Beginning at the back,  
use clips to section  
the hair. Take a section  
 
6
 
Using your Wet to Dry Straightener with  
Ionic Technology continued  
• Select another section of  
hair and repeat the process  
until all the hair has been  
straightened.  
• Finish with a few drops of  
D Frizz Smootheez Serum  
from PPS.  
• Switch off the appliance  
and remove the plug from  
the power outlet. Allow  
to cool completely before  
storing.  
• Please note that your styler  
can be used on dry hair.  
This will reduce the  
temperature to 175 degrees  
(setting 3).  
• Pushing the switch again  
will reduce the temperature  
to 150 degrees (setting 2).  
• Pushing the switch again  
will reduce the temperature  
further to 130 degrees  
(setting 1).  
• Pushing the switch again  
will turn the unit off.  
• To increase the temperature,  
switch the unit back on.  
Changing the temperature  
settings  
• Allow 30 seconds for each  
setting to reach the correct  
temperature.  
• When you plug in and  
switch on, the styler will  
automatically set at the  
hottest setting of 200  
degrees (setting 4).  
• We recommend that  
you do not use a higher  
temperature than necessary  
to straighten your hair. Start  
on a lower setting and move  
up if required.  
• If you wish to use a  
lower setting, push the  
temperature control switch.  
Note: You may hear a hissing  
 
7
Using your Wet to Dry Straightener with  
Ionic Technology continued  
sound and see steam. This  
is normal as the styler dries  
your hair.  
• For a more choppy look,  
choose pieces at random.  
Auto off function  
Setting 1 = 200°C  
Setting 2 = 175°C  
Setting 3 = 150°C  
Setting 4 = 130°C  
• For added safety,  
your hairstyler will  
automatically switch off  
after approximately 45  
minutes.  
Ionic Technology  
• After 44 minutes the LED  
will flash to indicate that  
you have one minute of  
styling left before the  
• The built-in ionic generator  
automatically produces  
a constant stream of  
negative ions whenever the  
styler is switched on.  
appliance switches off.  
• If you want to continue  
styling, simply switch  
off at the socket and then  
on again.  
• The ion indicator light will  
light up whilst your styler  
is in use.  
Please note that this is an  
added safety feature. Always  
switch off after use and  
unplug from the mains.  
Creating Flicks and Curls  
• Once the hair is heated, as  
you work towards the end  
of the section of hair, lift  
the styler up and out to  
 
8
create flicks.  
Help Line  
If you have any additional questions about using the Wet  
to Dry Straightener with Ionic Technology, please call the  
Sunbeam help line in Australia on 1800 025 059. In New  
Zealand, please call 0800 786 232.  
Care and Cleaning  
• After use, remove the plug  
from the power outlet and  
allow the hairstyler to cool  
before storing.  
• Do not wrap the cord  
around the appliance  
when not in use.  
• Store in a dry place.  
• The ceramic plates and  
the outside of the styler  
can be wiped with a soft  
cloth.  
 
9
 
Consumer Hotline  
Australia  
1800 025 059  
New Zealand  
0800 786 232  
‘Sunbeam’, is a registered trademark of Sunbeam Corporation.  
Made in China. Due to minor changes in design or otherwise, the product  
may differ from the one shown in this leaflet. Backed by Sunbeam‘s 2 Year  
Replacement Guarantee and National Service Network.  
© Copyright. SUNBEAM CORPORATION LIMITED 2005.  
(INCORPORATED IN N.S.W.) A.C.N. 000 006 771  
Sunbeam Corporation is a division of GUD Holdings Ltd.  
For more information or advice on this or any other Sunbeam appliance, visit  
www.sunbeam.com.au or contact the Sunbeam Consumer Service Line.  
Australia 1800 025 059 New Zealand 0800 786 232.  
08/05  
is a registered Trademark of Sunbeam  
Corporation Limited. ACN 000 006 771.  
© Sunbeam Corporation Limited 2005.  
 

Sharper Image MP3 Player SI738 User Manual
Snapper Chipper 1692371 User Manual
Sony Portable DVD Player DVP FX875 User Manual
Sony Projector 330 User Manual
Sony Speaker SS B3000 User Manual
Sony Video Game Console AC V16 User Manual
StarTechcom Network Card PEX4S952 User Manual
Sterling Thermostat 6016 M User Manual
Sub Zero Refrigerator IT 36R User Manual
TANDBERG Webcam D13166 05 User Manual