Superior Indoor Fireplace H1526 User Manual

HEARTH PRODUCTS  
KITS AND ACCESSORIES  
POLISHED BRASS OR BRUSHED STAINLESS  
LOUVER KITS  
INSTALLATION INSTRUCTIONS FOR POLISHED BRASS OR BRUSHED STAINLESS  
LOUVER KITS FOR USE WITH LENNOX HEARTH PRODUCTS GAS FIREPLACES  
GENERAL INFORMATION  
Center Bracket  
(For No.’s H1526 thru  
H1529 Only)  
Existing  
Bracket  
Existing  
Bracket  
These polished brass or brushed stainless louver kits may be used with  
Lennox Hearth Products gas fireplaces, to replace the factory installed  
black louvers. The kits contain seven louvers plus one louver with two  
pre-drilled holes (eight total) and these instructions.  
INSTALLATION INSTRUCTIONS  
Top Louver Assembly  
Step 1. Turn off the fireplace and allow it to cool before proceeding.  
Bottom Louver Assembly  
Step 2. Slightly lift and pull the existing top louver assembly away  
from the fireplace.  
Step 3. Slightly lift up the bottom hinged panel to disengage the  
small hooks on ether side of the panel. Pull forward and lower the  
panel down to open. Remove the assembly from the fireplace by  
removing the hinge screw on each end of the assembly.  
Existing  
Bracket  
Existing  
Bracket  
Center Bracket  
(For No.’s H1526 thru  
H1529 Only)  
Louver  
(With Pre-Drilled  
Holes)  
Step 4. Working with one assembly at a time, remove the existing  
black louvers separating the brackets from the assemblies (see  
Figure 1 ). To ease the removal of the brackets, use a side bladed  
screwdriver and mallet to "tap" down the bend in each bracket  
finger (restore the bend by hand before reassembly). Replace the  
black louvers with the brass or brushed stainless louvers (without  
the pre-drilled holes) using the existing brackets.  
Figure 1  
Step 5. Repeat Step 4 for the bottom louver assembly. Make sure  
to replace the pre-drilled black louver with the pre-drilled brass or  
brushed stainless louver.  
Step 6. Remove logo from existing bottom louver with pre-drilled  
holes and then snap the logo into the brass or brushed stainless  
louver with pre-drilled holes.  
Step 7. Reinstall the louver assemblies, reusing the existing screws  
to reinstall the bottom assembly.  
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.  
The manufacturer reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to discontinue colors, styles and products.  
Consult your local distributor for fireplace code information.  
LHP  
Printed in U.S.A. © 2004 by LHP  
1110 West Taft Avenue  
P/N 750,166M REV. B 07/2006  
Orange, CA 92865  
 

Sennheiser Microphone SLT23460FC User Manual
Shop Vac Vacuum Cleaner QSP Series User Manual
Snom Telephone VoIP Phone User Manual
Sony Computer Monitor CPD 17SF2T User Manual
Sony Digital Camera 4 166 207 111 User Manual
Sony Headphones MDR IF540RK User Manual
Sterling Plumbing Camera Lens SDRIOM 2 User Manual
Sterling Plumbing Outdoor Shower SP1500D Series User Manual
Sub Zero Cooktop CT15G User Manual
Tanita Scale BF 574 User Manual