MODEL H3172
MINI DIE GRINDER KIT
INSTRUCTION SHEET
EYE/EAR INJURY HAZARD!
Wear safety glasses and
hearing protection during
use of this tool!
INJURY HAZARD!
Always disconnect tool from
air to prevent unexpected
operation during service!
EXPLOSION HAZARD!
Never exceed 90 PSI!
Only use stones rated for
21,000 RPM or less!
Figure 1. Model H3172.
RESPIRATORY HAZARD!
Grinding produces fine
dust. Wear the appropriate
protection during use!
Die Grinder MUST have 3-4 drops of oil directly
dropped into the air fitting before each use as
shown in Figure 2.
Introduction
1
This mini air die grinder kit with ⁄4" NPT inlet
1
1
includes ⁄8" and ⁄4" collets, collet wrenches and
five grinding stones. Grinding stones include ball,
cylindrical and tapered shapes. It has a no load
speed of 21,000 RPM.
Inventory
A. Die Grinder................................................. 1
B. Wrenches ................................................... 2
C. Collet .......................................................... 1
D. Stones ........................................................ 5
Figure 2. Lubricating directly into air fitting.
If you need help with your new pneumatic tool,
call our Tech Support at: (570) 546-9663.
Operation
Insert your 1⁄4" shank into the collet. Using the two
wrenches, secure tool by tightening the collet nut
against the rotor shaft. To change collets, remove
the collet nut, replace collet and tighten collet
nut.
COPYRIGHT © MARCH, 2006 BY GRIZZLY INDUSTRIAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
#PC8029 PRINTED IN CHINA
|