Grizzly Tool Storage H7728 User Manual

MODEL H7728

ROLLING TOOL CART

INSTRUCTION SHEET

Introduction

This rolling tool cart with tool box requires some

assembly. Follow the instructions under each

Figure on the following page.

�

To begin, lay out all of the parts and compare

quantities to the inventory list given below.

If you need additional help with these instructions,

call our service department at: (570) 546-9663.

�

Inventory (Figure 1)

A. Tool Box w/ Upper Shelf ............................ 1

B. Side Support............................................... 2

C. Bottom Shelf............................................... 1

D. Vertical Support.......................................... 4

E. Handle........................................................ 1

F. Plain Caster................................................ 2

G. Pivoting Caster........................................... 2

H. 8mm Hex Bolt............................................. 2

I. 8mm Carriage Bolt ................................... 22

J. 8mm Hex Nut ........................................... 24

K. 6mm Phlps. Head Screw.......................... 16

L. 6mm Hex Nut ........................................... 16

M. 8mm Flat Washer..................................... 24

N. Front/Back Support .................................... 2

O. Angle Bracket............................................. 4

�

��

�

Figure 1. Inventory of parts.

WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE

OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.

#DD7590 PRINTED IN CHINA