®
HALO
L905
T Connector
L904
L Connector
To connect three track sections into a T
configuration. Field adjustable for either right
hand or left hand application. May be used as
feed point.
To connect two track sections at a right angle.
Field adjustable for either right hand or left hand
application. May be used as feed point.
Finish: White (P), Black (MB)
Finish: White (P), Black (MB)
L906
X Connector
L907
Outlet Box for use with
T-Bar ceiling
To connect four track sections into a cross
configuration. May be used as feed point.
L901, L903, L904, L905 or L906 connector also
required. 4”x 4” x 1 1/8”.
Finish: White (P), Black (MB)
Finish: White (P), Black (MB)
L908
Mini Joiner
L909
Floating Canopy and
Connector
A low profile connector to cleanly and crisply
join two straight track sections end-to-end.
(Note: The L908 is not a feed point).
Track can be connected to existing outlet
box located anywhere along the track. Comes
with canopy cover, connector, dead-end and
mounting hardware. 4 1/8” x 4 1/4” x 1 3/8”.
Finish: White (P), Black (MB)
Finish: White (P), Black (MB)
L950
Cord and Plug Connector
L951
Wire Way Cover for Pendant
Assembly Kit
12’ three-wire cord with grounded plug.
Maximum capacity 10 AMP
For track to be wired through stem (order one
for each feed point used). Shown with end
feed and pendant stem kit–order separately
Finish: White (P), Black (MB)
Finish: White (P), Black (MB)
L979
Conduit Continuation Kit
L980
Live End Conduit Adapter
Consisting of one left feed and one right feed.
To continue a run around obstructions. Designed
to accept 1/2” trade size conduit fitting (not
included).
Designed to accept standard 1/2” trade size
conduit fitting (not supplied). Use when
feeding to track through surface conduit
system.
Finish: White (P), Black (MB)
Finish: White (P), Black (MB)
L983
T-Bar Attachment Clip
L992
Pendant Kit Assembly
Allows track to be attached to inverted tee ceiling.
Order as follows: 2 kits for 2’ Trac; 2 kits for 4’
Trac; 3 kits for 8’ Trac and 4 kits for 12’ Trac.
Order 2 kits for 2’ Trac; 2 kits for 4’ Trac; 3 kits
for 8’ Trac; and 4 kits for 12’ Trac. Includes one
18” threaded steel stem, canopy and mounting
hardware.
L986
Mini-T Bar Clip
L48
48” Steel Stem
For mounting Trac on suspended ceilings with
mini-grid (9/16” wide) system.
For additional length with L992. Can be field cut.
Finish: White (P), Black (MB)
L994
45° Pendant Adapter
DE600 Dead End
For installing pendant mounted Power-Trac on
sloped ceiling. For use with L992 and L993.
Replacement Dead Ends for Single Circuit Track
(6 included)
Finish: White (P), Black (MB)
Finish: White (P), Black (MB)
COOPER LIGHTING
311
|