WIreless
66121
HeadpHones
InstructIons and precautIons
®
distributed exclusively by Harbor Freight tools .
3491 Mission Oaks Blvd., Camarillo, CA 93011
saVe tHese InstructIons. read all
precautIons and InstructIons.
©
®
Copyright 2008 by Harbor Freight Tools . All rights reserved. No portion of this document or any artwork contained
herein may be reproduced in any shape or form without the express written consent of Harbor Freight Tools. Diagrams
within this document may not be drawn proportionally. Due to continuing improvements, actual product may differ slightly
from the product described herein. Tools required for assembly and service may not be included.
For technical questions or replacement parts, please call 1-800-444-3353.
specIFIcatIons
assemblY/setup
1.
2.
Turn the ON/OFF Switch “OFF” on both the
Transmitter, and Headphones. Slide open the
Battery Compartment Cover on the Left Ear-
piece and, observing correct polarity, insert 2 -
AAA batteries (not supplied). Slide the Battery
Compartment Cover closed.
Headphones: 2 - AAA Batteries.
Transmitter: 2 - AAA Batteries
Batteries Not Supplied.
Power Source
Emitting Range 85 MHz
unpackIng
Open the Battery Compartment Cover on the
base of the Transmitter. Observing correct
polarity, insert 2 - AAA batteries (not supplied).
Close the Battery Compartment Cover.
When unpacking, check to make sure that the
item is intact and undamaged. If any parts are miss-
ing or broken, please call Harbor Freight Tools at the
number shown on the cover of this document as soon
as possible.
operatIon InstructIons
1.
2.
Plug the Standard Use Cable into the Audio-In
Socket on the Transmitter.
Important saFetY
InFormatIon
This product is not a toy. Do not allow children
to play with or near this item.
Plug the other end of the Standard Use Cable
into the Audio-Out (Headphones Symbol)
Socket on your TV, DVD, VCD, PC, or music
system.
1.
2.
3.
Use for intended purpose(s) only.
3.
4.
Slide the ON/OFF Switch on front of the Trans-
mitter to ON, the Power Light will come on. To
turn the power off, slide the Switch and the
Power Light goes off.
Inspect before use; do not use if parts are
loose or damaged.
4.
Maintain product labels and nameplates.
These carry important safety information. If
unreadable or missing, contact Harbor Freight
Tools for a replacement.
Pull out the Antenna on the Headphones and
turn on the Volume Control (also on the Head-
phones), the Power Light will come on.
5.
This device complies with part 15 of the FCC
Rules. Operation is subject to the following
two conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference received, including in-
terference that may cause undesired operation.
note: Volume of the received sound is deter-
mined by Volume control on both the Head-
phones, and your audio system.
5.
After you are finished using the Wireless
Headphones, turn off the Power to both the
Transmitter and the Headphones. Replace
the Headphones on Seat located on top of the
Transmitter.
|