Customer Service
N53 W24700 South Corporate Circle
Sussex, WI 53089
U.S.A.
A Huffy Company
Model 89224
SAFETY INSTRUCTIONS
FAILURE TO FOLLOW THESE SAFETY INSTRUCTIONS MAY
RESULT IN SERIOUS INJURY,
PROPERTY DAMAGE AND WILL VOID WARRANTY.
This unit is intended for display purposes only and
should not be used for play.
BASKETBALL
BALL
CENTER
BASKET
To ensure safety, do not attempt to assemble this system without
following the instructions carefully. Check entire box and inside all
packing material for parts. Before beginning assembly, read the
instructions and identify parts in this document. Proper and
complete assembly, use and supervision is essential for proper
operation and to reduce the risk of accident or injury. A high
probability of serious injury exists if this system is not installed,
maintained, and operated properly.
CENTER
•
•
•
•
•
During assembly, if using a ladder use extreme caution. Two
people are recommended for this operation.
If technical assistance is required, contact Huffy Sports’ Sample
and Display Technician.
Serious injury could occur if teeth/face come in contact with
backboard, net or rim.
Display recommended for 3” (7.6 cm) or 3-1/2” (9 cm) Round or 4”
(10 cm) Square poles only.
All instructions and warnings MUST accompany any display item
that is sold.
REQUIRED TOOLS AND
MATERIALS:
Wrenches: (Two each) 7/16”, 1/2”, 9/16”,
and 3/4” or Pliers
Most injuries are caused by misuse and/or not following
instructions.
Use caution when installing this unit.
•
•
Step Ladder, 8 ft. (2.4 m)
IMPORTANT!
To ensure prompt and correct handling of any problems, or to answer any questions, please contact the Sample
and Display Technician at 1-800-558-5234.
P/N 211678A
06/03
1
48” Fan Backboard
44” Fan
(Remains in
center location)
44” Fan
Backboard
CURRENT
INSTALLATION
DIAGRAM
EXACTA HEIGHT POLE
ASSEMBLY:
REMOVE & DISCARD
OR IT MAY BE LOCATED
IN A DIFFERENT
CORNER.
44” Steel Framed Acrylic
FRONT
The side with pegboard on
the top and bottom.
P/N 211678A
06/03
3
Install pole mounting hardware and pole for each
assembly.
WARNING
4
TWO PEOPLE ARE
NECESSARY TO MOUNT THE
ELEVATOR ASSEMBLY TO
THE POLE. ONE PERSON
SHOULD NOT ATTEMPT TO
DO THIS ALONE.
3-1/2” Rnd. Pole X 30” Pole
Upper Support
Railing
3-1/2” Rnd. Pole
TOP
VIEW
3-1/2” Rnd. Pole
10
8
3-1/2” Rnd. Pole
9
FRONT
P/N 211678A
06/03
4
INSTALLATION DIAGRAM
WARNING
Assemble display products per diagram below.
TWO PERSON MINIMUM
REQUIRED FOR THIS
PROCEDURE. NOT
FOLLOWING
RECOMMENDATION MAY
RESULT IN BODILY INJURY.
48” Fan
Backboard
44” Fan
44” Fan
FRONT
44” Rectangle
Steel Framed
Acrylic
48” Rectangle Steel
Framed Acrylic
P/N 211678A
06/03
5
Refer To Combo For
Goal Assembly
Instructions
Mount extension arm and
rim to backboard and
finger tighten as shown.
NOTE: For spring
loaded rim assembly,
refer to instructions
included with rim
hardware.
1.
1
2.
Secure hardware to extension
arm as shown and tighten
completely. Install pole cap (2).
2
4
7
5
5
3
6
P/N 211678A
06/03
6
|