The
CenTury
High Performance Oscillating Fan
OWner’S GuIDe
FOr MODeLS 94024, 94025
44242-01 03/18/2009
WeLCOMe
unPACKInG
Thank you for choosing the Hunter
Century Table Fan. This manual gives
you complete instructions for using
your fan. Here are some the features
you will enjoy with your fan:
As you unpack the fan, save the carton
and packing materials in case you want
to move or ship the unit in the future.
Carefully remove all items from the
box.
•
•
•
An attractive design that enhances
any decor
nOTe: It is best to have someone hold
the box while you lift the fan and the
protective packaging out of the carton.
A powerful Hunter motor for
maximum air flow
Make sure all shipping materials are
removed from fan before operating.
Three speeds to adjust your comfort
level
Before installing your fan, record the
following information for your records
and for warranty assistance.
Model name ______________________
Date Code ________________________
Date Purchased ___________________
Where Purchased __________________
_________________________________
Please attach your
receipt or a copy of your
receipt to this manual
for future reference.
44242-01 03/18/2009
3
GrOunDInG InSTruCTIOnS
LIne COrD SAFeTy TIPS
This appliance is for household use
only and may be plugged into any
230-volt AC electrical outlet (ordinary
household current). DO nOT
1. neVer pull or yank on the cord or
the appliance.
use any other type of outlet.
2. To insert plug, grasp it firmly and
guide it into the outlet.
3. To disconnect the appliance, grasp
the plug and remove it from the
outlet.
4. Before each use, inspect the line
cord for cuts and/or abrasion
marks. If any are found, the
appliance should be serviced
and the line cord replaced. Please
return it to our Service Department
or to an authorized service
representative.
5. neVer wrap the cord tightly
around the appliance, as this could
place undue stress on the cord
where it enters the appliance and
could cause it to fray and break.
Continental european
Plug & Socket
FIGure 1
6. DO nOT operate appliance if the
line cord shows any damage, if the
appliance works intermittently or
stops working entirely.
4
44242-01 03/18/2009
OPerATIOn
1. Place the fan on a dry, safe, flat
surface where it cannot fall or be
pulled by the cord.
the oscillation knob down. To stop
oscillating, pull the oscillation knob
up. The oscillation knob is located
on the top of the fan housing, near
the handle. This appliance is for
household use only.
2. Plug the fan into a 230-volt
AC electrical outlet (ordinary
household current). DO nOT use
any other type of outlet. Make sure
that the rated voltage of the fan
is the same as the power source
before plugging it into the power
source.
3. Turn the fan“On”or“OFF”by sliding
the Power/Speed Control to the
right or left. The power should
always be OFF before unplugging
the fan.
4. To select the speed, move the
Power/Speed Control from OFF to
the desired speed setting: O (off), I
(low), II (medium), III (High).
Handle
Oscillation
Knob
Motor
Housing
5. To control the upward and
downward direction of airflow,
loosen the screw on the side of
the fan housing neck. Adjust to
the desired angle and tighten the
screw.
up/Down
Adjustment
Screw
6. To make the fan oscillate, push
Base
Power/Speed Control Switch
FIGure 3
44242-01 03/18/2009
5
MAInTenAnCe
This fan is permanently lubricated and
will not require additional lubrication
(oil) for the life of the fan. This fan
requires little maintenance and contains
no user serviceable parts. DO nOT try to
fix it yourself. Contact qualified service
personnel if servicing is needed.
7. reassemble the fan after blades
and grills have dried completely.
First, replace the blades. When
replacing the blade screw, you
should feel some resistance as
the screw engages the bar. next,
align the grills, replace the ring,
place the hook in the hole and
replace the screw.
TO CLeAn:
1. Before cleaning, turn fan off and
unplug from electrical outlet. Wipe
off excess dust with a lintfree cloth.
8. DO nOT plug fan into an electrical
outlet until it has been fully
reassembled.
2. To ensure adequate air circulation
to the motor, keep vents located at
the rear of the motor housing free
from dust accumulation. A vacuum
cleaner hose can be used to clean
these vents.
3. DO nOT immerse the fan in water
or any other liquid.
CLeAnInG GrILL AnD BLADe:
1. Turn the fan off and unplug from
the electrical outlet.
2. Disassemble grills by carefully
removing the screw on the bottom
of the grill and by squeezing the
ring to remove the hook from the
hole.
Front Grill
Back Grill
Blade
Screw
Handle
See Figure 4.
Oscillation Knob
Motor
Housing
3. Disassemble blades by carefully
removing the blade screw
behind the blades. The blades
should slide off.
4. Grills and blades may be cleaned
with mild soap and water.
up/Down
Adjustment
Screw
5. use a soft, slightly damp cloth to
wipe the remaining fan parts.
Blade
ring
6. DO nOT allow water or any
other liquid to get into the motor
housing or base.
Base
Power/Speed Control Switch
FIGure 4
6
44242-01 03/18/2009
STOrAGe
TrOuBLeSHOOTInG
1. Disassemble and clean fan before
storing.
PrOBLeM
•
Fan will not oscillate.
2. Keep the original packaging for the
purpose of storing the fan.
SOLuTIOn
3. ALWAyS store the fan in a dry
place.
•
Push down on knob on top of motor
housing to activate oscillation.
4. neVer store the fan while it is still
plugged in.
5. neVer wrap the cord tightly
around the fan.
PrOBLeM
•
Can not adjust the angle of the fan.
6. DO nOT put any stress on the cord
where it enters the fan, as it could
cause the cord to break.
SOLuTIOn
•
Loosen the screw on the side of the
fan neck. Adjust to the desired angle
and tighten the screw.
If you have tried these troubleshooting
solutions and still have trouble, call 01-
901-743-1360 (uSA) or visit our Web site
44242-01 03/18/2009
7
WArrAnTy
HunTer FAn COMPAny PrODuCT
HunTer CenTury POrTABLe FAn
5 yeAr LIMITeD GuArAnTee
express Manufacturer’s Guarantee (the “Guarantee”)
This Hunter Century Portable Fan (“Century Fan”) is guaranteed by The Hunter Fan Company
of 2500 Frisco Avenue, Memphis, Tennessee 38114 united States of America (tel 01 901
743 1360) (“Hunter”) for the benefit of the original user or consumer purchaser (“you”)
for a period of five years after the original date of purchase, against defects in material or
workmanship (“Defect”). If such a Defect occurs, Hunter will repair or replace the Defective
part free of charge, or refund the purchase price at your discretion. Labour to repair the
Defective Part will, likewise, be provided free of charge.
This Guarantee relates solely to Defects to the Century Fan.
What does the Guarantee not cover?
This Guarantee does not extend to the finish on any metal portion of the Century Fan.
The Guarantee does not cover any damage caused to any property by a defective Century
Fan, except, in the case of non-business purchases, for loss or damage caused by a defective
Century Fan resulting from the negligence of Hunter.
This Guarantee will not apply if:
(a) the Century Fan is not purchased in european union; or
(b) any fault, defect, loss, damage, injury or claim results from the improper or incorrect
use of the Century Fan, improper repairs of the Century Fan by non authorised persons, the
direct or indirect acts of a third party, or any other reason whatsoever with the exception of a
Defect in your Century Fan.
The Guarantee will no longer be effective if you cease to own the Century Fan.
How do you claim under this Guarantee?
If you wish to claim under this Guarantee please return the Century Fan to the retailer from
where you initially purchased the Century Fan. your Century Fan should be properly packed
to avoid damage in transit and we will not be responsible for any such damage that occurs if
you fail to do this. you must provide your sales receipt or other document establishing proof
of purchase when claiming under the Guarantee.
Statutory rights
In the case of non-business use purchases, this Guarantee is in addition to, and in no way
affects, your statutory rights relating to faulty or misdescribed goods or services.
Business use
If you have bought this Century Fan acting in the course of your business, trade or
profession, then this Guarantee is in place of and to the extent permitted by law replaces and
excludes all other warranties and conditions whether express or implied by common law,
statutory or otherwise.
FOr ADDITIOnAL InFOrMATIOn reGArDInG THe
HunTer FAn COMPAny, PLeASe reFer TO THeIr
8
44242-01 03/18/2009
|