iLive Speaker System ITP100B User Manual

USER’S GUIDE

V:1028-0721-10

ITP100B

Bar Speaker with Dock for iPhone/iPod

For the most up-to-date version of this User’s Guide, go to www.ilive.net

Important Safety Instructions

1. Read these Instructions.

FCC Warnings

2. Keep these Instructions.

3. Heed all Warnings.

WARNING: Changes or modiﬁcations to this unit not expressly ap-

proved by the party responsible for compliance could void the user’s

authority to operate the equipment.

4. Follow all instructions.

NOTE: This equipment has been tested and found to comply with

the limits for a Class B digital device, pursuant to Part 15 of the FCC

Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equip-

ment generates, uses, and can radiate radio frequency energy and, if

not installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one or

more of the following measures:

5. Do not use this apparatus near water.

6. Clean only with a dry cloth.

7. Do not block any ventilation openings. Install in accor-

dance with the manufacturer’s instructions.

8. Do not install near any heat sources such as radiators,

heat registers, stoves, or other apparatus (including

ampliﬁers) that produce heat.

•

Reorient or relocate the receiving antenna.

9. Do not defeat the safety purpose of the polarized or

grounding - type plug. A polarized plug has two blades

with one wider than the other. A grounding type plug

has two blades and a third grounding prong. The wide

blade or the third prong are provided for your safety.

When the provided plug does not ﬁt into your outlet,

consult an electrician for replacement of the obsolete

outlet.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

•

Consult the dealer or an experienced radio/TV technician for help.

Additional Warnings

•

The apparatus shall not be exposed to dripping or splashing and

that no objects ﬁlled with liquids, such as vases, shall be placed on

apparatus.

L’appareil ne doit pas être exposé aux écoulements ou aux éclabous-

sures et aucun objet ne contenant de liquide, tel qu’un vase, ne doit

être placé sur l’objet.

10. Protect the power cord from being walked on or

pinched particularly at plugs, convenience receptacles,

and the point where they exit from the apparatus.

11. Only use attachments/accessories speciﬁed by the

manufacturer.

Main plug is used as disconnect device and it should remain readily

operable during intended use. In order to disconnect the apparatus

from the mains completely, the mains plug should be disconnected

form the mains socket outlet completely.

La prise du secteur ne doit pas être obstruée ou doit être facilement

accessible pendant son utilisation. Pour être complètement décon-

necté de l’alimentation d’entrée, la prise doit être débranchée du

secteur.

Use only with a cart, stand, tripod, brack-

et, or table speciﬁed by the manufacturer,

or sold with the apparatus. When a cart is

used, use caution when moving the cart/

apparatus combination to avoid injury

from tip-over.

12.

•

Battery shall not be exposed to excessive heat such as sunshine, ﬁre

or the like.

Les piles ne doivent pas être exposées à de forte chaleur, tel qu’à la

lumière du soleil, au feu ou autres choses de semblable.

13. Unplug this apparatus during lightning storms or when

unused for long periods of time.

•

Caution marking is located at the rear or back of the apparatus.

Attention marquage est situé à l’arrière ou à l’arrière de l’appareil

14. Refer all servicing to qualiﬁed service personnel. Ser-

vicing is required when the apparatus has been dam-

aged in any way, such as power-supply cord or plug is

damaged, liquid has been spilled or objects have fallen

into the apparatus, the apparatus has been exposed to

rain or moisture, does not operate normally, or has been

dropped.

The marking information is located at the rear or back of apparatus.

Les informations de marquage est situé à l’arrière ou à l’arrière de

l’appareil.

This symbol indicates that this product

incorporates double insulation between

hazardous mains voltage and user

accessible parts.

CUsTOmeR HeLPLINe | 1-888-999-4215

iLive

Bar Speaker wIth Dock For Iphone/IpoD

Features

• Works with iPhone

• Made for iPod

• Auxiliary input (RCA)

• Basic iPhone/iPod controls

• Supports Universal docking brackets

• Soft-eject iPod docking drawer

• Cloth net speaker grill

• FM radio

• Station memory presets (20 FM)

• Treble and bass controls

• 2 channel stereo system

• Digital clock

• DC power: requires AC/DC power

adapter (included)

• Single alarm

• Gradual wake

• Wake to iPhone/iPod or radio

• White LCD display

• Sleep timer

• Video output

• Line input (3.5mm)

• Remote control

• Last user setting memory

Included

• ITP100B

• AC/DC power adapter

• Remote control: requires 2 AAA

batteries (included)

• Docking brackets for iPhone/iPod

iLive

taBLe oF contentS

IntroDuctIon

Setup

cLock

Iphone anD IpoD & VIDeo output

FM raDIo, auX Input, anD LIne Input

coMpany InForMatIon

CUsTOmeR HeLPLINe | 1-888-999-4215

iLive

IntroDuctIon

PUSH TO

OPEN

SoFt eJect

Dock For

DISpLay

iphone/ipod

power/aL oFF

Press to turn the

power oﬀ or on.

Press to turn the

alarm oﬀ after it

has sounded.

VoLuMe/cLock

(-/+)

Press to adjust

the volume. When

setting the clock,

press to adjust the

hour and minute.

POWER

AL OFF

SOURCE

CLOCK ADJUST

VOLUME

CLOCK

VOLUME

CLOCK

Source/cLock

aDJuSt

Press to switch

between iPod, FM,

AUX and LINE IN

modes. In power

oﬀ mode, press

and hold to set the

clock.

VIDeo out

(coMpoSIte)

Dc power Input

auX In (Stereo

rca)

AUX IN

VIDEO DC IN 10V

OUT

LINE IN

LIne In (3.5mm)

reSet

FM ANT.

RESET

Press to reset the

bar speaker to it’s

default settings.

FM wIre

antenna

iLive

Mute

Press to mute the

volume.

cLock/SLeep

With the bar speaker

powered oﬀ, press

and hold to set the

clock. With the bar

speaker powered on,

press repeatedly to

set the sleep timer.

aLarM

Press to view the set

alarm. Press and hold

to set the alarm.

POWER/AL OFF

MUTE

preSet

Press to save an FM

radio station as a

preset.

power/aL oFF

Press to turn the

power oﬀ or on. Press

to turn the alarm oﬀ

after it has sounded.

CLOCK

/SLEEP PLAY/PAUSE

ALARM

+/-

Press to cycle

through preset FM

radio stations.

pLay/pauSe

Press to play or pause

a docked iPod.

SOURCE

PRESET

tun/rew/FwD

Press to tune the FM

radio. Press to skip

between tracks on

a docked iPhone

or iPod. Press and

hold to search and

individual track on

a docked iPhone or

iPod.

Source

Press to switch

between iPod, FM,

AUX and LINE IN

modes.

Menu (+/-)

TUN/

REW

TUN/

FWD

SELECT

Press to move up and

down in the menus

on a docked iPhone

or iPod.

VoLuMe

Press to adjust the

volume.

SeLect

REPEAT

FM ST.

Press to make

selections on a

docked iPhone or

iPod.

treBLe/BaSS (+/-)

Press to adjust the

treble or bass output

from the bar speaker.

VOLUME

TREBLE

BASS

Press to move back

through previous

menus on a docked

iPhone or iPod.

chapter/pLayLISt/

aLBuM

Press to cycle

through CHAPTERS,

PLAYLISTS, or

ALBUMS on a docked

iPhone or iPod.

CHAPTER PLAYLIST

DISPLAY

ALBUM

SHUFFLE

repeat

Press to repeat the

current track or

entire album.

DIMMER

DISpLay

In radio mode, press

to view the clock.

FM St.

Press to turn FM

Stereo oﬀ or on.

DIMMer

Press to adjust the

brightness of the

display.

ShuFFLe

Press to shuﬄe the

order of tracks played

from a docked

iPhone or iPod.

CUsTOmeR HeLPLINe | 1-888-999-4215

iLive

Setup

power

DEO DC IN 10V

Plug the included AC/DC power

adapter into the Dc power Input

on the bar speaker and a standard AC

power outlet

RESET

remote

Requires 2 AAA batteries (included)

iLive

cLock

Setting the Sleep timer

Setting the clock

1 Press the power button to turn the

bar speaker on.

1 Press the power button to turn the

bar speaker oﬀ.

2 Press the cLock/SLeep button on

the remote repeatedly to set the

sleep timer.

2 Press and hold the Source/cLock

aDJuSt button for 3 seconds.

The time on the display will begin

blinking.

3 After the set amount of time

has expired, the bar speaker will

automatically power oﬀ.

3 Press the VoLuMe/cLock (+/-)

buttons to adjust the hour.

4 Press the Source/cLock aDJuSt

button.

5 Press the VoLuMe/cLock (+/-)

buttons to adjust the minute.

6 Press the Source/cLock aDJuSt

button to ﬁnish setting the time.

Setting the alarm

1 Press the power button to turn the

bar speaker oﬀ.

2 Press and hold the aLarM button,

on the remote, for 3 seconds.

The alarm time on the display will

begin blinking.

3 Press the tun/rew/FwD buttons on

the remote to adjust the hour.

4 Press the aLarM button.

5 Press the tun/rew/FwD buttons to

adjust the minute.

6 Press the aLarM button.

7 Press the tun/rew/FwD buttons

to switch between wake to iPod or

wake to FM radio, as indicated on the

display.

8 Press the aLarM button to ﬁnish

setting the alarm.

CUsTOmeR HeLPLINe | 1-888-999-4215

iLive

Iphone anD IpoD & VIDeo output

Docking an iphone/ipod

1 Press the top right corner of the

SoFt eJect Dock For iphone/

ipod to expose the dock for iPhone/

iPod.

2 Swing the StaBILIty LeVer down

to stabilize the bar speaker while

docking an iPhone or iPod.

StaBILIty

LeVer

3 Locate the numbered bracket that

ﬁts the iPhone/iPod model that will

be docked.

using the Video output

Each included bracket has a number

on it, indicating which iPhone/iPod

model that bracket is compatible with.

See the separate bracket chart page to

identify which bracket is needed.

1 Connect an RCA video cable (not

included) to the VIDeo output on

the bar speaker and the video input

on a television.

2 Power the bar speaker on and press

the Source/cLock aDJuSt button

to switch to iPod mode.

4 Snap the bracket into place over the

iPhone/iPod connector in the dock.

5 Connect the iPhone or iPod to

the connector inside the Dock for

iPhone/iPod.

3 Follow the instructions for DOCKING

AN iPhone/iPod

Make sure the iPhone or iPod’s TV OUT

setting is set to ON.

When the speaker is plugged in, using

AC power, the docked iPhone or iPod

will charge.

4 Adjust the connected television to

the correct input setting.

5 Video played through the docked

iPod will now play through the

connected television.

playing an iphone/ipod

1 Follow the instructions for DOCKING

AN iPhone/iPod.

2 Press the power button to turn the

bar speaker on.

3 Press the Source/cLock aDJuSt

button to switch to iPOD MODE.

4 Press the pLay/pauSe button on the

remote to begin playing music from

a docked iPhone or iPod.

10 iLive

FM raDIo, auX Input, anD LIne Input

playing the FM radio

using the Line Input

1 Connect an audio source to the LIne

Input using an 3.5mm line input

cable (not included).

1 Press the power button to turn the

bar speaker on.

2 Press the Source/cLock aDJuSt

2 Press the power button to turn the

button to switch to FM RADIO MODE.

bar speaker on.

3 Press the tun/rew/FwD buttons on

3 Press the Source/cLock aDJuSt

the remote to tune the FM radio.

button to switch to LINE IN MODE.

Adjust the FM WIRE ANTENNA to

improve FM radio reception.

4 Use the native controls on the

connected audio device to

begin playing music through the

connected bar speaker.

Saving radio Stations

1 Follow the instructions for PLAYING

THE FM RADIO.

using the auX Input

2 Tune to the desired FM radio station.

1 Connect an audio source to the auX

Input using an RCA stereo cable

(not included).

3 Press the preSet button on the

remote.

4 Press the +/- buttons on the remote

to select a preset.

When connecting the RCA stereo cable,

match the colored plugs on the cable

to the colored connections on the bar

speaker.

5 Press the preSet button to save

the current FM radio station to the

selected preset.

2 Press the power button to turn the

bar speaker on.

6 Press the +/- buttons to cycle

through FM radio presets.

3 Press the Source/cLock aDJuSt

button to switch to AUX MODE.

4 Use the native controls on the

connected audio device to

begin playing music through the

connected bar speaker.

CUsTOmeR HeLPLINe | 1-888-999-4215

iLive 11