Instructions
®
313704E
GL-11 Injector
EN
For Single-Line Parallel Automatic Lubrication Systems. For professional use only.
Part No.: 24A918
3500 psi (24 MPa, 241 bar) Maximum Working Pressure
Important Safety Instructions
Read all warnings and instructions in this manual. See
your Automatic Lubrication System Manual for com-
plete Warnings, Installation, Operation and Trouble-
shooting instructions. Save all instructions.
PRESSURE RELIEF PROCEDURE
Follow this procedure any time you are instructed to
Relieve the Pressure; shut off the pump; clean or ser-
vice any part of the system; or install or clean dispens-
ing devices.
1. Disconnect power.
2. Disable air supply to pump by either:
•
•
Closing bleed-type air valve OR
Disconnecting quick disconnect air coupler on
vent valve.
1/8” npt
1/4” npt
SKIN INJECTION HAZARD
9.5”
240.5 mm
High-pressure fluid from gun or dispense valve, hose
leaks, or ruptured components will pierce skin. This may
look like just a cut, but it is a serious injury that can
result in amputation. Get immediate surgical treat-
ment.
•
Do not point gun or dispense valve at anyone or at
any part of the body.
Do not put your hand over the dispense outlet.
Do not stop or deflect leaks with your hand, body,
glove, or rag.
1/2” npt
3.75”
95.2 mm
2.75”
69.8 mm
•
•
•
Follow Pressure Relief Procedure, when you stop
dispensing and before cleaning, checking, or servic-
ing equipment.
ti13690
2-3/16” (55.6 mm)
2-27/32” (72.2 mm)
|