6
5
4
2
8
3
1
7
INSTALLATION INSTRUCTIONS:
1. REMOVE THE 1/4-20 X 5/8" BHCS HOLDING THE MOUNTING
BRACKET TO THE REST OF THE DOCKING STATION (THE SCREWS
IN THE PLASTIC SIDE-MEMBERS ON EACH SIDE OF THE DOCK).
PULL MOUNTING BRACKET OFF OF DOCKING STATION.
D
D
2. SET MOUNTING BRACKET ON TOP OF DESIRED SURFACE SO
THAT 3 OF THE HOLES ON THE MOUNTING BRACKET LINE UP WITH
3 TAPPED HOLES OF THE MOTION ACCESSORY. (IF 3 HOLES ARE
NOT AVAILABLE THEN USE 2.) SEE *RECOMMENDED HOLES* OF
THE MOUNTING BRACKET.
3. FASTEN THE MOUNTING BRACKET TO THE MOTION ACCESSORY
USING (3X) 1/4-20 X 5/8" BHCS (OR 2 DEPENDING ON AVAILABILITY).
4. PLACE DOCKING STATION OVER TOP OF MOUNTING BRACKET
SO THAT THE 2 THREADED HOLES IN EACH FLANGE OF THE
MOUNTING BRACKET LINE UP WITH THE 2 HOLES IN EACH PLASTIC
SIDE-MEMBER.
5. FASTEN THE DOCKING STATION BACK TO THE MOUNTING
BRACKET USING (4X) 1/4-20 X 5/8" BHCS.
C
C
6. TIGHTEN ALL FASTENERS TO THE INDICATED TORQUE
RECOMMENDATIONS.
(4X) 1/4-20 X 5/8" BHCS
(120 +/-10% IN-LBS)
(3X) 1/4-20 X 5/8" BHCS
(120 +/-10% IN-LBS)
*USE 3 SCREWS TO FASTEN
DOCK DOWN IF POSSIBLE*
(MOUNTING BRACKET OF
DOCKING STATION)
B
B
*RECOMMENDED HOLES
FOR MOUNTING WITH
2 SCREWS*
HARDWARE KIT CONTENTS:
PRODUCT I.D.
DATE
01-30-07
DS-PAN-101
PRODUCT NAME
*RECOMMENDED HOLES
FOR MOUNTING WITH
3 SCREWS*
A
A
DS-PAN-101
DOCKING STATION
WARNING: ALL HAVIS INC. PRODUCTS ARE DESIGNED WITH SAFETY OF USE AND INSTALLATION IN MIND. HOWEVER,
IT IS THE SOLE RESPONSIBILITY OF THE OWNER/OPERATOR OF A VEHICLE USING HAVIS INC. MOUNTING AND
DOCKING EQUIPMENT, TO INSURE THAT THE EQUIPMENT IS INSTALLED SO THAT IT WILL NOT INTERFERE WITH VEHICLE
OPERATION, INTERFERE WITH SAFETY DEVICES, OBSTRUCT VIEW OF DRIVING CONDITIONS, OR IN ANY WAY
DEGRADE OCCUPANT SAFETY. IMPROPER INSTALLATION CAN CAUSE SERIOUS INJURY IN THE EVENT OF AN
ACCIDENT. INSTALLATION SHOULD ONLY BE PERFORMED BY QUALIFIED PROFESSIONALS. COMPUTERS AND
MOTION DEVICES MUST BE MOVED TO AND STOWED/SECURED IN THEIR SAFE DRIVING POSITIONS BEFORE
OPERATING VEHICLE.
PRODUCT DESCRIPTION
WEIGHT: (LBS)
THIS PRODUCT IS USED WITH THE PANASONIC
CF-28/29/30 TOUGHBOOK COMPUTERS
DRAWING NUMBER:
6.6
REV. DATE
D3-0036-IS-G
(SHEET 1 OF 2)
(THE FEATURES OF THIS PRODUCT MAY BE LIMITED
DEPENDING UPON THE MODEL OF COMPUTER USED.)
1-800-524-9900
WWW.HAVIS.COM
12-07-09
F-730-019 REV A
8
7
6
4
3
2
5
1
|