Quick Start Guide
JT01-32E2 32" Liquid Crystal Display TV
This guide is designed as a reference to help you start using your LCD TV quickly. Please refer to the User's Manual for more detailed installation and safety instructions.
Front View
Rear View
1
2
3
1
2
3
4
5
6
4
14 13
12 11
10
9
8
7
6
5
7
8
9
1. Volume down button
2. Volume up button
3. OSD Menu button
4. Channel down button
5. Channel up button
6. Enter button
7. Power button
8. Infrared receiver
9. Power LED indicator
1. Audio Output for AV, S-Video or YPbPr
components (L/R)
2. Audio Input for AV, S-Video or YPbPr/
HDMI-DVI components (L/R)
3. Audio Input for VGA
4. RF Antenna / Cable TV Input
5. SCART2 / SCART2-SV Input
6. SCART1 Input
8. S-Video Input
9. YPbPr/ HD Component Video Input
10. VGA (15 pin) Signal Input from Computer
11. HDMI2 Input Terminal (19 pin)
12. HDMI1 Input Terminal (19 pin)
13. AC Power Input
14. AC Power Switch
7. Composite Video input
Making Connections
Connecting to Antenna/Cable TV
Getting Started
Selecting Input Source
1. Connect one end of the UHF/VHF (Antenna)
or CATV cable to the TV IN jack (UHF/VHF
IN jack) on the back of the TV.
TV
YPbPr
AV
1. Make sure your TV is turned on and a device
such as a DVD player is connected.
2. Press the SOURCE button on the remote
HDMI2
SVIDEO
control and use the / button to select
the required input source between PC, HDMI1,
HDMI2, TV, YPbPr, AV, SVIDEO, SCART1,
SCART2, and SCART2-SV.
2. Connect the other end of the UHF/VHF
(Antenna) or the CATV cable to the Antenna
or CATV socket.
HDMI1
PC
SCART1
SCART2
SCART2-SV
Connecting to VCR, VCD or DVD Player
3. Press ENTER to confirm your selection.
The illustrations below show you how to connect your TV to a VCR, VCD or a DVD player.
With RCA AV cable
With S-Video cable
Auto Channel Scan
Follow the instructions below to automatically preset the channels for your TV
before watching it for the first time.
1. Press the "MENU" button on your remote control or the control panel.
2. Use the / button to select Channel Menu.
3. Press the / button to select country.
4. Press the "ENTER" button to start Auto Scan.
With YPbPr cable
With SCART1
Note: After performing Auto Scan, you need not do it again when turning
on your TV next time.
Auto Scan
C h a n n e l
A u t o S c a n
M a n u a l S t o r e
N a m e
U K
Connecting the Power Cord
1. Plug the power connector into the AC-IN
input jack on the rear cover of the TV-set.
2. Insert the three-pronged plug at the other
end of the power cord into a power outlet.
3. Turn the main power switch on to supply
power to the TV.
OSD
S e l e c t
MENU E x i t
JT2002310661P
© Copyright 2007 Hannspree, Inc. All rights reserved.
|